Phono Preamp


Hi!
I upgraded my equipment recently with a Triode Lab 2a3 integrated and a pair of Klipsch Forte III. My turntable is still a Project Carbon 2Xperience Classic, and the phono preamp it's a Pro-ject Phono Box S.

I am thinking about to change the phono preamp and wait a bit for the turntable upgrade. Is very difficult to get a demo for home test, so, according with your experience, witch pre-amp do you recommend with this equipment?

Or is better to go to the full pack and change both, turntable and amp?

ramon74
^ precisely; I prefer not to be using tubes in audio gear.  A 2500 watt transmitter is fine with low fidelity SSB or CW signals which are only dealing with a frequency range of 300 to 2000 hz; fidelity really isn't an issue.
Years ago when I had a really nice Fischer receiver which ran all tubes, it was nice to turn it on, wait for the warm up and then listen.  But I just prefer the modern low noise solid state devices today.  
It is precisely devices like preamps, DACs, etc in which small signal tubes are used that have no downside when compared to similar S.S. components. With tube amps things get a bit more complicated. 
Can't make a statement about a phono-pre without knowing the cartridge your using.
2channel8"Can't make a statement about a phono-pre without knowing the cartridge your using"

That is a silly response the best preamps for Music Reproduction Systems are versatile enough to successfully and faithfully accommodate a variety of phono cartridges after all if you thoroughly consider the matter most listenwrs will own they're phono preamp for many years as they're phono cartridges wear out and are replaced with new cartridges yes a phono preamp and cartridge do need to be matched but I would always suggest and recommend that the preamp be purchased first.