Vandersteen 2wq x-over help

Are you looking for the cut off point for your main amp? The 2Wq comes with a variable crossover (WX-2) that goes between the amp and preamp with a selector switch. Once the desired sound is achieved the box is removed and replaced with a plug in resistor at the back of your amp. This relieves the main amp and speaker of low frequencies. Without the WX-2 your only other option is to try different resistors. These are high quality resistors with male and female RCA's.

I hope this helps.

Thanks all. I didn't get WX-2, but I did get a set of 50k resistors. I was aware of the trial and error aspect of choosing the right resistor value from having read various posts elsewhere, but I was hoping to hear from someone, who already tried it with the Sapphire, who could give me some advice.

Again, thanks to any and all that can help.

Don't you want the input impedance not the output?

I guess I don't understand what you want. It sounds like you are trying to match a subwoofer crossover to your amplifier. Is this correct?

The dip switches are 1-8, and the ones noted below are in the ON position.
Start out by going with the 200 K setting but do not go lower I will try and see what would measure higher
when I get a chance
Johnnyr
200KOhm : None
100KOhm : 4 8
50KOhm : 3 7
33KOhm : 3 4 7 8
20KOhm : 2 6
15KOhm : 2 3 4 6 7 8
10KOhm : 1 5
5KOhm : 1 2 3 4 5 6 7 8