Vandersteen 2wq x-over help

Thanks all. I didn't get WX-2, but I did get a set of 50k resistors. I was aware of the trial and error aspect of choosing the right resistor value from having read various posts elsewhere, but I was hoping to hear from someone, who already tried it with the Sapphire, who could give me some advice.

Again, thanks to any and all that can help.

Don't you want the input impedance not the output?

I guess I don't understand what you want. It sounds like you are trying to match a subwoofer crossover to your amplifier. Is this correct?

The dip switches are 1-8, and the ones noted below are in the ON position.
Start out by going with the 200 K setting but do not go lower I will try and see what would measure higher
when I get a chance
Johnnyr
200KOhm : None
100KOhm : 4 8
50KOhm : 3 7
33KOhm : 3 4 7 8
20KOhm : 2 6
15KOhm : 2 3 4 6 7 8
10KOhm : 1 5
5KOhm : 1 2 3 4 5 6 7 8

Further thought is that with a nice Amp like you have
your best served with the Vandersteen 5 A High pass units.
they are available on audiogon in either RCA type or XLR
You can contact me if you have no Vandy dealer and I will coach you through.
Best Johnnyr