Sonus Faber peeling leather


Hi
I recently bought a pair of SF Lilium, BNIB, and upon unpacking, found that the leather had started to peel. The dealer took them back. The dealer is having it re- wrapped but I was wondering if anyone has done this properly (not just sticking another layer over it) or does it have to go back to the factory to be done properly?
Thanks
J
128x128jared_lee
That last pic was pretty bad. 
If the dealer is having Sonus Faber replace the leather, I would not be concerned-Especially, if they can insure the rest of the speaker is working as it should.
 If an outside party is doing the work, I might be inclined to take a pass.
Bob
https://ibb.co/album/gRLr8v
Hi everyone,
I just went to take a look at the speakers. One side was done. They were done very professionally. The fit and finish was as good as new. They used a more durable felt type material that will be more durable than leather in tropical weather where I am and the dealer will warranty the job for 10 years, so I have decided to keep them. Most SF leather will eventually peel in the tropics. Thanks for all your advice!
Cheers
J
Hey Jared, may I know where you went to replace the leather as the leather on my cremonas are peeling too. Thanks
Slightly off subject but noticed a small manufacturing defect on Olympica models at recent show - the plastic molding around mid (and tweet) wdnt sit flush - either side of mid at thinnest point. I cant understand how that is acceptable tbh.