Subwoofer Question

I have been thinking about replacing the ML with two smaller subs such as the REL T/7i’s or T/9i. I do like bass so I feel I need/want a sub. In my research I also keep reading that subs make the midrange sound better if you have the right setup.

Don’t replace, but do add the two. Even better, add three. The problem you’re having isn’t so much the sub being ML as that its just one sub. With only one you’re forced to move the damn thing around trying to find the one spot where the magic happens and the bass is extended and smooth. But the magic never happens. Never can. Because, physics. No matter where you put one sub it will always result in lumpy uneven tubby bass that never goes as deep as you want but thumps more than you want.

The answer is lots of subs. The more subs you use the lower each one can be, you be able to turn the ML down a lot, and this helps reduce boominess. Also with more subs you can set it to roll off lower, maybe even completely eliminating any output in the boominess range. Another thing that helps is they go different locations so create different modes in different places and at different frequencies. Finally you are not relying on one alone to extend really deep. These things all add together to result in much smoother, deeper and more articulate bass than you could ever get with just one sub, EQ/GIK regardless.

Have you, or are you able to, run the Anthem Room Correction software on your ML Sub (labeled PBK)?  If not, you haven’t maximized the potential of what that woofer can do.  Running the Room Correction will make a shocking improvement by helping it integrate better to your room and blend more seamless with your speakers.

I haven’t done the room correction. I seem to remember you needed a PC and it wasn’t compatible with a Mac but I will check into that.

thanks

I just checked and the software is available for Mac. I will get the kit and do this.

thanks for the suggestion @cbrents73

puppy-t,
nothing wrong with the subwoofer- i believe the issue is that your main speakers have very extended bass output- down to 35 hz less 3db. This is the "F3" frequency (where bass response is 3 decibel down from the rest of the audio range). The "F3" frequency is typically the starting point for subwoofer crossover setting.
Setting the crossover so low means that the sub will not have much contribution - few musical passages have output this low.
If the crossover is set higher, then you will have lots of issues because the signals will overlap, not be in ideal phase or timing, etc.
I had this same problem and despite the best integration tuning with measurements, positioning, crossover and phase adjustments, ARC room correction- in the end I could not get the system to sound great most of the time and I got rid of the subwoofers.
Room correction software will adjust the frequencies but not the phase issues.  
The only option to get this to work was to filter the bass from my main speakers with an additional crossover- say cutting them at 80 Hz for example instead of letting them run full range. This might be a option for you but I chose not to.
My successful option was to run a more powerful amp to drive bass through my main speakers. Yours is certainly up to the task.
The other option is for you to set the crossover on the sub to 35 hz and be prepared to enjoy the occasional really deep bass notes.
peace.