Cartridge, Compliance, try what in my JVC UA-7082 Arm?


So, what to try in my new JVC UA-7082 Tonearm when it comes? (effective length 282mm) (11-1/8")

Guidelines? Advice? (I never bothered learning about compliance, I guess now's the time).

Anyone know the Mass of the UA-7082 Tonearm without a cartridge _______?
.....................................

Self Imposed Restrictions:

High Output, 4.0mV or more (to avoid tube preamp hum zone until it's repaired).

MM Only. (I am fundamentally opposed to MC pre-pre amp, as well as needing high output).


.......................................

Motley Crew On Hand:

4 headshells, none special

Shure MicroRidge Stylus and V15VxMR Cartridge

Shure V15VMR Cartridge (no stylus, I gave it a dirty look and it broke, horribly brittle shaft)

Shure 97xe Elliptical Stylus and Cartridge (despite it's low pedigree it's my current favorite).

Shure N78S Stylus (fits 97xe) (I did not inherit the 78's someone threatened me with).

Shure M44E Stylus and Cartridge

Audio Technica MicroLine AT440ML OOC Stylus and Cartridge

Audio Technica AT7000 body, no stylus

Audio Technica ATP-2

Audio Technica Series VIII P mount 

Audio Technica ___? Came with the AT120 TT (tracks 2.5g, I never used it) 

................................
It's a busy time, it doesn't get here till mid Jan, so theirs time to research.

Thanks in advance, Elliott






elliottbnewcombjr
The seller could be Chakster himself. Not that there is anything wrong with that, except....
Anyone notice how little titanium is used in tonearms and cantilevers?
There is a good reason for this. It rings like a bell. Actually, you can make bells with it. I have a classic Merlin Ti bike and every time you hit a bump big enough and a cable slaps the frame, TINGGGGG! It is also sort of rubbery. You will never see it in a bike fork because it results in very squishy handling. 
Yes, I guess that's why the SR71 Blackbird spy plane was made of titanium; it's soooo rubbery.
Post removed