What is "break in" and what difference does it make? In amps? Preamps? Speakers? More?

+1 delkal

delkal
I am pretty sure everyone agrees speakers need some kind of break in. They are mechanical devices and it takes a while for the cone / surround to become pliable. Next on my list is anything with capacitors. The new dielectric undergoes some changes with use. This phenomenon has been known for over 100 years and is not snake oil. This break in can easily be shown scientifically and some capacitor data sheets even have recommended break in procedures. I don’t have a firm opinion on transistors or IC’s. So lets say maybe (or it won’t hurt).

But when it comes to breaking in a wires, interconnects or speaker cables I don’t buy it. Some people even claim if you unplug, move or even touch a wire it will take some time for it to settle back in. Besides, speakers are more than simply mechanical devices, you know, what with the internal wiring and electronic crossovers, including capacitors. Not to mention not everyone agrees speakers require break in. 

>>>>You just said it yourself. The dielectric material needs to break in. That itself explains why interconnects, speaker cables, power cords, HDMI cables, digital cables, etc. require break in. Hel-loo!

You just said it yourself. The dielectric material needs to break in. That itself explains why interconnects, speaker cables, power cords, HDMI cables, digital cables, etc. require break in. Hel-loo!

Just because there is the same dielectric word describing both don’t let that confuse you. They play different roles. A capacitor stores a relatively large amount of energy between the plates and having the right dielectric configuration is very important for optimum efficiency. And although I didn’t mention it there is also capacitor break in of the conductive plate surfaces that is equally important.

For wires a dielectric is just a fancy term for an insulator. There should be minimized interactions between the wires and that is what insulators do. I have never heard of an insulator that doesn’t work that good at first but gets better at insulating after use.

Yes, I know you never heard of it, sweet pea. That’s OK. Well, now you have. It’s all good. 🤗

Filter capacitors in amps and preamps have something called 'forming up' where they adjust to the operating voltages to which they are subjected, being electro-chemical devices. This takes some time and until that occurs the power supply will not be acting correctly. Not sure how long it takes, 50-250 hours? but its not that hard to measure that they do change- the power supply voltage itself goes slightly higher and there is less noise on the supply rails.

So that explains part of break-in. But coupling caps appear to have a break-in property as well and to me this isn't as well explained, but plenty of people report changes in coupling caps as they apparently break in.

We hear break-in artifacts in our own gear and for that reason (and to prove reliability) we play the gear in our shop before shipping. The first ten hours or so see the most dramatic changes and this period of break-in isn't experienced by most people as most manufacturers don't ship as soon as the bench tests are passed. We have noticed however that somewhere in the last 20 years that phenomena is vastly reduced over what we used to experience so we suspect that some part we are using is a bit better at its job now than 20 years ago. Generally speaking though its unimportant as we put at least three days of operation on something before shipment. Often we'll run it longer than that- up to a week. But customers consistently report break-in improvements and have been doing so as long as we've been in business, and having experienced it myself many times I just accept that its a thing. I think power supply filtration is most of it.