BEST HARMLESS/SIGNATURELESS SPEAKERS CAPACITORS.

Dear @grannyring  : The ODAM caps has to wait for a test till exist the caps values for my speakers mid-range.

R.

Dear friends : I can't find out yet the source for the Wima 100uf that goes in the speaker crossover.

In the mean time I'm thinking to make a really critical test that it's to change the V-cap Teflon Cu for a MKP 10 in the high pass filter in my bi-amp speaker/subwoofer.

I don't use the subwoofer high pass electronics instead I made the high pass filter taking advantage that my Levinson amps are coupled by cap at the input.

To do that I need first than all open the amps and take a look/measure the distance between the circuit boards holes because the original cap was 2.2uf and for the high pass is way lower value and due that the Wima are radial caps I think maybe I can't do it directly because the lower value cap has a shorter distance in between pins and I don't want to add cable to solder at the board.

I will do all my effoprt I can because if the Wima can, at least, even the V-cap Teflon Cu well that could be admirable for say the least. 
We will see.

Regards and enjoy the MUSIC NOT DISTORTIONS,
R.

Hi Raul... finally ordered a pair of the MKP10s to try against my 4.7uF Duelund Tinned-Copper CAST high-pass tweeter caps.  I'll let you know what the comparison sounds like.  Also planning on trying the ODAMs in my pre-amp, but am not quite ready to spring the $150 for a trial... easy to pull the trigger on the $20 for the WIMA capss and shipping.

Dear @cal3713  : Good, we will see what happens with your experiences about.

Other that the ODAM has a limited cap values and due that I own the OIMP  where the MKP 10 are way superior performers I could think that maybe the ODAM is not the response against Wima but I never know that till I testesd.

R.

You can just parallel the ODAMs for use.  Lower inductance that way and that can be a good thing.  I used two 4uf caps instead of an 8 uf for example.