Made My Own USB cable

Made my own usb cable.

Since one of my recent usb cables became defective, and had to send it off for repair, I decided to try my hand at a DIY usb version. I have made in the past interconnects, speaker cables and power cords, and I have always tried to use the best materials available.

Well, I just completed the usb cable. And to my surprise it is a lot better than any usb cable I have tried. Way better than some other highly acclaimed $$$ cables that I have on hand or others that I have tried. Hard to believe, but I’m not kidding it is that good.

Construction:

The wire that was used is a 24-gauge .9999 soft annealed pure silver wire. I kept the wires separated and placed them on clear (about 4”) wide packing tape with the sticky side up. I then placed another tape over the wires thus sealing the wires. I used usb connectors that were easy to use and that also helps to keep the wires separated. I also ran a separate pure silver ground wire of the same material. Link to the usb connectors below.

zdyCGTime USB 2.0 A Screw Terminal Block Connector USB 2.0 A Male Plug to 5 Pin/Way Female Bolt Screw Shield terminals Pluggable Type Adapter Connector Converter 300V 8A(2Pack) (Male)

From first play I knew I had made something special. Playing some Hi Rez CCR song, “Green River” where the guitar starts from the right now comes from way over to the right. I didn’t think it could go so far over to the right! It wasn’t a difference that was hard to tell. No, what I heard was a quite natural sound that seemed so comfortable and relaxed but was also very dynamic that possessed a wide, wide open soundstage. The bass has that boogie quality and the mids and treble were again the best I have heard with my equipment. There is a presence in the sound quality that is hard to believe, singers, and images reach out to touch. I made two versions; one was about ½ meter long the other about 1 meter. I’m still undecided as to which length sounds the best.

But I am confused, it won’t pass a DSD signal? Very strange… but, 16-24/96 or 192hz is no problem.

So, cable wire quality and the barest construction method used appears to be very important, even with usb digital cables.

ozzy