2. analog
  3. 154895-37539

Cartridge Tonearm compatibility

Hi,
I need some help calculating cartridge/tonearm compatibility. I am considering building a DIY turntable. I have purchased a Maglev table and a Jasmin motor from China on ebay. I am currently building a custom plinch and arm-board.I have purchased a Jelco SA750E tonearm. I am considering a Dynavector XX2MKII cartridge. I have looked at resonant frequency calculators but quite frankly they are above my knowladge. Would the Dynavector XX2MKII be a good match for the Jelco SA750E. The tonearm mass is 13.26gr. The cartridge weight is 8.9 gr and the cartridge compliance is 10 mm/N.
128x128garyr46
yogiboy's avatar
yogiboy
5,674 posts
 
If you put in the information, this calculation chart will show you what the resonance frequency will be for the arm and cartridge. Between 8 and 14 hz should be fine!
http://www.mh-audio.nl/Calculators/RF.html
chakster's avatar
chakster
6,144 posts
 
Would the Dynavector XX2MKII be a good match for the Jelco SA750E. The tonearm mass is 13.26gr. The cartridge weight is 8.9 gr and the cartridge compliance is 10 mm/N.

This is a compliance at 100Hz
You need a compliance at 10Hz or all your calculations will be wrong. 

To convert 100Hz to 10Hz you have to multiply on 1.7
So the actual dynamic compliance of your Dynavector is 17 cu ! 

Use 17cu when you calculate tonearm/cartridge resonance. 

millercarbon's avatar
millercarbon
12,531 posts
 
Can you believe, I built this turntable and never once considered any of that technical mumbo jumbo? https://systems.audiogon.com/systems/8367
noromance's avatar
noromance
9,771 posts
 
Not a Maglev as in the floating platter table?
millercarbon's avatar
millercarbon
12,531 posts
 
Right. Clearly someone is not thinking practically.
More to discover