2. cables
  3. 154952-133116

Synergistic Research AC Master Coupler on all Components including Subs Over-Kill

I've done' a bit of reading on power cables.  One cable that keeps coming up in discussions is the Synergistic Research AC Master Coupler.
Also, I read Nordost's Foundation Theory paper.  https://www.nordost.com/dealer%20downloads/FoundationTheory.pdf  
In this paper's information they state, "Consistency is King!"  It goes on to read, "Use the same power cords to feed all the key components in the system. Once you have an audiophile cord between the wall and your distribution block, make sure that any further cords are of the same type or, at the very least use the same technology and materials. This usually means employing AC cords from a single manufacturer."

Millercarbon often suggests the- Synergistic Research AC Master Coupler.  I've done enough research that with patience, I can purchase this cable around the $250 - 350 range.

A couple of questions:
1. Would it be "overkill" purchasing Synergistic Research AC Master Coupler for all of my six components that can use an upgraded power cord (my DAC is vintage and has a fixed power cord).  If helpful the component are:- IsoTek EVO3 Aquarius power conditioner
- Primaluna integrated tube amp.
- VPI Classic Signature TT-  Manley Chinook Phone Stage
-  two Rel S/3 subwoofers

2.  Is the suggestion of employing power cords of the same type and from the same manufacturer hold any water among the folks here at Audiogon?

3.  Could the Rel S/3 be plugged into the medium power outlets of the my Power Conditioner? Those medium-current outlets deliver 1,150W continuous power.  I gotta think the answer is yes, but I gotta ask!  The sub's manual states it draws 22 watts at idle.  I have no clue what current they draw at my listening levels.  Not terribly loud.
Thanks!
malatu
millercarbon's avatar
millercarbon
12,531 posts
 
1. No. Not at all. Given the level of your associated components the Master Coupler is entry level. Full disclosure, I reject the notion of there being any such thing as overkill. You could put a $10k SR cord in there and be blown away. So even that would not be overkill. It would be a misallocation of resources, which is not at all the same.

2. No its a sieve. Bucket without a bottom. Red herring. McGuffin.

3. Yes and it should be. You want everything on one circuit as a general rule to prevent ground loop hum and keep noise levels down.
jtcf's avatar
jtcf
1,620 posts
 
I would buy two or three and try them on different components first to give you an idea where they would do the most good.Plug the Rels into your conditioner and crank it up.Then you'll hear if they run out of steam.They only draw a lot of power for seconds at a time.
I like to mix brands rather than stick with a full loom,just my personal preference.Others like to keep with one brand.Good luck to you!
malatu OP
58 posts
 
I love this forum!  Thanks!
ebm
9,311 posts
 
No!!
More to discover