List of plinth builders for Technics SP10 MK3

Lewm

That's hard to do especially on the MK2 as all the circuit cards are installed on the plate and they plug together via sockets on them with no wiring harness.  Everything of course is possible but it would require quite a bit of engineering to do.  

Good Listening 

Peter

I was only thinking of the mk3, where electronics are outboard. It’s been done by many, including Steve Dobbins. Probably OMA too.

lewm

I posted a picture of the innards of the SP10mk2 on my systems page for reference

https://systems.audiogon.com/systems/4923

Good Listening

Peter

Thx, but like I said, Rich has a mk3, and my remarks about shedding the outer chassis were only as regards the mk3. And it’s been done many times before by various companies. The motor of the mk3 is apparently easy to dissect from its chassis.

best-groove   
"all other manufacturers charge prices higher than the turntable value"The SP10 MK3 is no longer well regarded and worthy of high level upgrades?