Unfairlane
Did you make this particular cable?
Did you make this particular cable?
- ...
- 19 posts total
How many new cable manufacturers have there been over the past 20 years? How did all those people start out? I'm not saying they beat all the cables I've never tried in my system, but I made vh audio's silver interconnects and really like them (https://www.venhaus1.com/diysilverinterconnects.html). Pictures available in my system. Better than the old MITs they replaced, and better than my previous diy attempt using duelund tinned copper. At least I know what materials are going into the cables, and that no-one's going to beat my diy cables' silver purity no matter how much they charge. Not a bad place to start. |
williewonka1,999 posts02-24-2020 12:37pm@audiomaze - take a look at these... http://image99.net/blog/index.html The perform great, having exceptional dynamics, clarity and details and an enormous image.. Wow, the direction of the wind makes a difference. CCW vs CW. Once again silver clad over copper in the construction, BRIGHT? SIZZLE? What type of speaker system are you using, round, planar, electrostatic? I just can't handle the ear bleeding HF that silver cladding on anything causes. Man oh Man, same with a lot of single hard dome speaker setups. Couple that with this type of cable, COTTON TIME, for me. The planar/ribbon systems I use or have used, they will boil your ears using this type of anything, IC, PC, Speaker any and all connects. But a LOT of people I met at shows an such, just love that type of SUPER bright reproduction. I'll pass! How was it recorded, what was the intent? I like Line Source speakers for the most part, most other people like Point Source speakers. Haya different folks, ay? The network SPEAKER cables I built are sounding better all the time.. About 260 hours or so now, go for it, well worth it.. Regards |
@oldhvymec - RE:... Once again silver clad over copper in the construction, BRIGHT? SIZZLE? Silver cladding is NOT the problem, niether is solid silver - it’s the type of insulation and the cable geometry that causes the ear-bleading distortions you are hearing. The right geometry and insulation having a low dielectric constant allows the HF details through with clarity, smoothness and amazingly fine detail. But - just for people that prefer the sound of copper I do include a Duelund Tinned Copper version of the Helix Interconnect and the speaker cables and power cables only use Duelund Tinned Copper. As for MY speakers - Gershman Audio Sonograms - they have conventional drivers. But that’s just my opinion - and BTW, one shared by a couple of people that have actually used my cables on their Maggies and reported great results As the old saying goes - The Proof of the pudding is in the eating - not the speculation based on one’s experience with OTHER cables that just happen to use silver cladding - they are very different cables The other thing with DIY - you are free to use whatever wire you like - it's the geometry and insulation that is important here! So until you try them...…. . Regards - Steve |
- 19 posts total