Linear Tracker ...I was wondering
Pivoted arms just involve a different set of compromises—- what I would suggest is pick a cartridge and table that can work for both: imo SOTA and Dynavector and then buy X pivot arm and an ET2 ( why ET2 ? Cause if you buy it reasonable you can resell at zero loss ) fixate on proper setup and listen to both... |
^^^^ The ET2 came out the same year as CD debuted - 1982. If it wasn’t such bad timing who knows. As it is there are over 2500 out there and originally cost $800. Good condition samples of the original 2.0 can be had for $800-1000. And resell again same price. So yes I agree on that. however. Tom - I feel it is the wrong candidate for a cold comparison because there is a learning curve to setup, and to learn what is possible. It is unique in design and requires time to learn how to set up for best performance. Even dealers/reviewers only ever figured out maybe 6 out of 10 on what was possible. Cheers |
Technics SL-10 is hard to find "in a good shape", over 5 years of research almost every unit i've seen for sale required service, and most functions does not work. Belt replacement requires, lubrication, cleaning etc. There are some nice units already serviced, but the price is crazy nowadays, especially if there is a Technics P205c mk4 cartridge instead of mk3 (or some cheap junk p-mount).I must have struck lucky then Chakster and I will count my blessings! Picked mine up of eBay few years back, working perfectly but no cartridge. Got three different p mounts now ( no NOT cheap junk p mount ones). Sure it does not have quite the same SQ as my 401/505 combo but for the price it does not embarrass itself in my main system at all. A precursor of what might come next I may add...... You can't stop the signal! |
That's cool. I wish to have SL-15 in collection, i already have P205c mk4 cartridge :) |
Jag, you might wonder how a $1000 low-production tonearm could compete with a $5000 unit from a big manufacturer. The answer is, "off-the-shelf." The Terminator uses clever engineering instead of gobs of custom machining and pretty plating. Everything is made from off-the-shelf industrial material. The most common procedures are drilling and 90 degree straight cuts - cheap. Few curves or slots. No plating, no exotic materials, no sculpted elements. Even the air bearing is improvised from common angle stock. Just utilitarian pieces, mostly made from common aluminum shapes. Good engineering, not eye candy. Obviously, from the comments, not for everyone. |
