NEW Cerious Technologies Upgrade - Graphene Matrix Cables


CT Graphene Matrix Cables:

I have been using the CT GE cables for almost two years.
I recently traded up for a full loom of CT Graphene Matrix cables, including speaker, interconnect and PCs, and I wanted to share my experience. I started by replacing only the ICs to try and hear the differences.

The new Matrix interconnects sounded better than the GE immediately after install. I found the original Graphene Extreme ICs to be good but not on the same level as the outstanding GE speaker cables. As break-in started to clear things up, I can hear more clarity and detail not heard before. The ICs are incredible on their own and at the 30 hour mark, I can hear a clear superiority over the GE ICs. I recently started using the Teo Game Changer ICs and preferred them over GE but the Teo has now fallen to the new Graphene Matrix ICs. My Teo’s were and are great, and it is stunning to experience Cerious Technologies commitment to making great technology better.

On the third day of listening to the GM ICs. I couldn’t wait anymore, Having too much fun. I then installed the speaker cables and power cords once I had a pretty good feel for the sound of the GM ICs.

With the full loom of GM cables running in they are going through some strange changes and definitely need time to settle down before realizing what they can really do and very important Bob says to not move them. Since I have a home office I can let them run in all day. I’m at around 120 hours now and they are still improving. Here’s what I’m hearing:

Extended highs and tighter lows.
More detail and better low level listening
Drums are tighter, more clearly defined. So real is the snap of the snare drum. The bass has more depth, seemingly goes deeper, lower. This aspect stands out the most.

I am not in the industry, I’m not an engineer, I don’t work for Cerious Technologies, but I am a fan of the cables and am enjoying what my system is capable of.

I’m closer to my own pinnacle of sound reproduction than ever before.

Lance

lancelock
Curious if anyone else out there is getting zapped from these PCs?

I recently had reason to be handling the area behind my amp and got zapped. Pulled the Matrix from the amp and was getting zapped when touching the outer shielding. Put back an older extream and its not shocking me and the sub goes into standby again.

Told Bob about it and was promised a replacement would be shipped out the next day along with another cord I had ordered. Not even getting responses to my emails now

About giving up on his whole deal. Would be good to know if this is an isolated failure or common. Considering if I shouldn't pull all the cords out of my system before I get a fried component or worse. Wife is way pissed seeing that expensive cord laying out on the table.


I believe it's a somewhat isolated case, but I know it has happened to at least another audiophile.

I had a similar issue with a power cable as mentioned where I’d get shocked when touching the chassis and cable at the same time. I found that the ground cable became disconnected from the IEC plug.

I resolved the problem after reconnecting and securing the ground cable to the plugs.
steve_noodles
I had a similar issue with a power cable as mentioned where I’d get shocked when touching the chassis and cable at the same time. I found that the ground cable became disconnected from the IEC plug.

I resolved the problem after reconnecting and securing the ground cable to the plugs.
You actually had two problems: The faulty cable (which you corrected) and a component fault that caused the chassis to be hot. Did you troubleshoot the cause of that?
@cleeds - I didn’t troubleshoot the chassis being hot as the cable faulty cable made other components hot as well. Thus, it appeared to be the common denominator in my system.