MSB vs dCS Bartok


Thinking about the MSB Premier vs dCS Bartok in a active ATC speaker rig.

I want to consolidate my system down from a Naim NDS/252 front end. 
So as a one box DAC/streamer/preamp. which should be better ?


rfc
Brinkman Nyquist Mk2 has a lot of fans and is supposed to sound very good indeed and of course has tubes if that's your thing.

But has always it's about synergy and imho the most important thing I have learned is that you have to demo at home in your own room....

Good luck.
@4425
do NOT count on it sounding better going direct. i’ve personally never found that i would be happy long term with that. there’s always some intangible element missing that makes music special. imho
I have similar experience with the Select, it sounds definitely more lifeless without the preamp in the system.

Following suggestions above, I tried out the Select direct then via pre, hi & low output.

Strangely, the volume set to 100 via pre sounds better than either 106 or 100 in direct & better than 106 via pre. 106 in direct sounds better than 100. Overall, the order is: via pre 100, pre 106, then direct 106 (hi).
No all systems (DAC to amp to speaker matching), no mater how good, will give a good result with DAC straight to amp. It’s not always fault of the DAC or it’s v/c. 
Overall, the order is: via pre 100, pre 106, then direct 106 (hi).

Sound maybe like bit stripping to me, how much higher than 106 can your MSB go?
If this is the case leave the MSB where it sounds the best direct, and use a good passive preamp after it, then you'll get all the best sound of the direct hookup without introducing the coloration/distortions of an active preamp 

Cheers George