Unusual(?) spade connection


Hi everyone,

I have seen some speaker cable spade connections on the amp side where one prong of the spade is inserted into the post hole rather than how it should be placed, where you would insert bare wire.  

The old MIT2 biwire cable I have has spades that are too narrow for the posts on my Hegel and Ampzilla monoblocks. I have never had biwire fitted speakers until obtaining a pair of B&W Matrix 801 S2s and would like to "get the whole experience".

I can fit one prong of the MIT2 cable in each of the amp post holes. But I didn't tighten the post cap(?) in fear of bending or breaking anything.

It just seemed rather strange but if there are no reasons against doing this, I could save a lot of time and expense by not needing to purchase cables (or modify the MIT2s).

Is this a bad idea?

Thanks and stay safe everyone!
hleeid
@lowrider57  - You mentioned:  You may find doubling the biwire cable to one speaker binding post will provide the best sound.

Interesting. I guess I should plan on spades vs banana plugs.
Thanks for pointing this out! 
I will try doubling as you suggested.
Try both ways since you already have the biwires. My point is you'll have a heavier gauge cable if you double it.


Bi-wire and shotgun were the first two things I tried that convinced me to look deeper into wire. This was decades ago, back when I was using ordinary hookup wire. So it cost next to nothing to try. (Even then I was so cheap- did I really want to cut 15 ft of wire off the roll to try this unlikely idea out? Lol! Seriously!) To this day I still recommend trying the easiest/simplest/cheapest thing first just to see if it works. If the idea has any merit at all then you should be able to hear it regardless of how well its done.

But this is merely the first step. Then once you know the next is to figure out what is the best way to go about it. So once I knew cables really could make a difference the next thing was to figure out just how much and what is the best value way to go about it. In other words what you are doing, trying elevators and all these different things. 

If you keep going like this, trying a lot of different things, listening close as you can for all the differences, noticing which are better and in what way and by how much, you will very soon be looking back in wonder at how much progress you have made. This is roughly somewhere between a thousand and a million times better than read/talk/buy.
Post removed 
Thanks for all the replies!
Looks like I just filled my schedule for the week!

Excited to experiment with the cables and speaker placement.  Thank God these speakers are on wheels!

And yes, what a difference the simple/cheap things can do!

I was so anxious to hook up the B&Ws as I never owned speakers like this, that I used short Kimber Kable cables.

The short cables didn't allow me to pull the speakers far from the front wall.  So after using the much longer MIT2s with one prong on each amp binding post, I was able to move the speakers around.

Huge difference!  Especially in the bass.

Then I discovered that the midrange/tweeter units atop each speaker can rotate.

This helped to tame the brightness (which may be due to the untreated living room).  

I also followed a suggestion by millercarbon to another poster to first try Styrofoam cups to elevate cables.  Had to triple the cups and wrap rubber bands around them because the MIT2 cable is thick as a garden hose and very heavy.

Although I couldn't really tell any difference with the short cables that I have, there was a difference with the much longer (20 ft) MIT2s.

Makes me wonder how many have purchased a nice pair of speakers, set them anywhere, no thought to basic experimentation and sell them because they didn't like the sound.

Stay safe everyone!