Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

@sakso136   M6 is correct.

From Grzegorz:  The thread is M6. The spike height is 33 mm and the thread height is 10 mm.

Thks david_ten,
i pulled the trigger.
i ll report my findings here.

Heads up fellow Nenuphar owners, there is a First Watt SIT-2 listing on USAM.

I have a tweak for those of you who have your Nenuphars sitting on Townshend Seismic Platforms. This was inspired by an email I recently received from an audiophile friend who was considering the Siesmic Platforms and ended up speaking with Max Townshend himself. Max strongly encouraged him to get as much of the speaker’s bottom surface touching the Platform’s plate. And mentioned spikes accomplished the opposite. I pondered this for a while and remembered I had some 1" x 2" maple trim in the garage. I cut the trim into two pieces the width of the speakers. I tilted the speakers back and placed the wood strips underneath the very front spanning the width of the speaker--the height of the trim (which is really 1 and 3/4") was just slightly higher than the spikes. Voila, after just a few minutes of listening I had audible proof that Max might know what he’s talking about. Better focus, separation and very noticeably better depth. I haven’t tried a thinner strip of wood to support the speaker’s rear but I think I will. (I’ve got a little time on my hands.) If you spend $20 on this tweak only to end up thinking I’m crazy, well, blame Mr. Townshend.

Stephen...thanks for sharing this. Were your Nenuphars on the stock spikes? 

Also, any updates on impressions and overall results since your last major one (over a month ago)? Thanks.