Try Audio by Van Alstine
switching between two amplifiers; issues of power
Hello and thanks for your insight.
I am ordering a second amp, an inexpensive class D amp, fueled by two Icepower modules, the 300AS1, I believe, which outputs 150 watts into 8ohms and 300 into 4 ohms. It can handle a load as low as 2.7 ohms.
This is a Swiss-assembled amp that I've ordered because my almost utterly amazing Nuforce STA200, also a $500 amp, runs hot when I play it a little into the loud.
My question: when the new amp arrives and I want to swap the speakers to the new XTZ amp, can I leave the Nuforce plugged in and "on," while there are no speaker cables affixed, and visa-versa with the other amp. I would like to compare the two amps and I don't want to damage an amp for lack of speaker load.
Thank you and best regards,
I am ordering a second amp, an inexpensive class D amp, fueled by two Icepower modules, the 300AS1, I believe, which outputs 150 watts into 8ohms and 300 into 4 ohms. It can handle a load as low as 2.7 ohms.
This is a Swiss-assembled amp that I've ordered because my almost utterly amazing Nuforce STA200, also a $500 amp, runs hot when I play it a little into the loud.
My question: when the new amp arrives and I want to swap the speakers to the new XTZ amp, can I leave the Nuforce plugged in and "on," while there are no speaker cables affixed, and visa-versa with the other amp. I would like to compare the two amps and I don't want to damage an amp for lack of speaker load.
Thank you and best regards,
- ...
- 18 posts total
- 18 posts total