Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

FYI - There are two Nenuphar active listings here on the 'Gon. Both in the Black finish. One New, the other a showroom demo.

Thanks for the heads up David.  The 1 cubic foot sealed box DIY version will be my next audio journey and it's good to see the thread staying alive. Really looking forward to the building experience. Curious if I'll be able to pull off a high gloss black piano paint job.

"Curious if I'll be able to pull off a high gloss black piano paint job."

Try Ferrari Red. :-)
http://www.thesupercars.org/wp-content/uploads/2011/04/2010-Ferrari-599-GTO-red.jpg
It would look good with the gold drivers.
https://logos-download.com/wp-content/uploads/2016/03/Ferrari_logotype_on_the_red_car.jpg

Robert

• Hi fellas,
  

i cant interpret these specs to know how this integrated will be a good match to nenuphars.
knowing that low damping factor is prefered for the nenuphars....
any help decoding these specs and opinion on compatibilty with the cubes.

HD & N< 0.15 % @ 5W output, < 1 % @ 40W output < 5 % @ 52W outputInput Impedance>15 kohmsOutput Impedance<0.8 ohms (damping factor >10 reference to 8ohms load @ zero global feedback)
Thks

Hello,
Looking at the level of the stated distortion and accompanying output impedance and damping factor of >10 (Does this mean But <20?) is consistent with a zero NFB (Or very low level of NFB). So based on these measurements they suggest that (on paper) this amplifier should be a pretty decent match with the Nenuphar. Only an educated guess as other aspects of the amplifier aren’t known. Speaker impedance =8 ohm ÷ output impedance of roughly 0.8=10 which is the DF (At least for 8 ohms).
Charles