2. digital
  3. 1124942256

Behringer DEQ2496 HELP

After reading the raves about this product, I finally bought one along with the matching microphone tonite. Put in my system, eager to try room correction. The first 2 attmepts produced some curves that I wasn't crazy about, but seemed plausioble. Now, all it does is push all the bands above 125 all the way to maximum boost, and all the bands below 125 to maximum cut. When displaying the RTA of the pink noise, there is nop more htan a 15 dB range between the highest and lowest levels on the curve (as if that were small!)Also, one of the primary reasons I bought it was for equalizing low frequency room problems, yet it suggests htat anyuthing below 100Hz not be included in the auto EQ.
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
honest1
ecruz
402 posts
 
Eldartford-
Thanks for the response! I think that answers everything. If I have further questions I'll post back.

I can't believe how good everything sounds putting this "active" component in the signal path. I always thought the shortest, most passive path, from source to speakers was always best. One more myth shot down.
ecruz
402 posts
 
One more question.

How do I know when Auto Eq is finished? The manual says you have to stop it. How do I know when to stop it?
warnerwh
539 posts
 
Hit the button next to the "stop Autoeq" when it's lit. There's three pages there so be sure you're on the right page. Page three will let you watch it do it's thing.
ecruz
402 posts
 
I've never let it go long enough for the light to come on. I let it run on the "fast" setting for 5 minutes, then switched it to "slow" for another 5 minutes, then just watched it until the bouncing back and forth was minimal and then I stop it. By minimal I mean just a few frequencies going up a notch or two, then down a notch or two.

I can't believe how much clearer the sound is. In my book this is a "must audition" piece.
eldartford
4,262 posts
 
Ecruz...In my experience 5 minutes is way overkill. 30 seconds in FAST mode just about nails it. Then I watch in SLOW mode, probably for another 30 seconds just to be on the safe side, but nothing much changes after the FAST phase.
More to discover