On initial comparison, whichever has less upper midrange/treble (bypass or eq)is likely to sound muffled. Let your ears adapt before you pass judgment. If after listening for a while, it still sounds muffled, try one (or both) of two things: (a) whatever cuts the auto-eq made above, say 2kHz, reduce those cuts by half (e.g., if it is -6 dB, manually adjust to -3 dB), or (b) use one of the parametric bands as a treble control by setting it to H 6dB with a frequency of 2 or 3 kHz; boost by a dB or two. Also, make sure that you're not being misled by an overall level difference - try turning up the volume on the setting that sounds muffled.
Behringer DEQ2496 HELP
After reading the raves about this product, I finally bought one along with the matching microphone tonite. Put in my system, eager to try room correction. The first 2 attmepts produced some curves that I wasn't crazy about, but seemed plausioble. Now, all it does is push all the bands above 125 all the way to maximum boost, and all the bands below 125 to maximum cut. When displaying the RTA of the pink noise, there is nop more htan a 15 dB range between the highest and lowest levels on the curve (as if that were small!)Also, one of the primary reasons I bought it was for equalizing low frequency room problems, yet it suggests htat anyuthing below 100Hz not be included in the auto EQ.
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
Does anyone know why it is coming up with such odd equalization curves, even though it is reading the data, which doesn't look so bad? Also, how bad is the product at low frequencies?
- ...
- 136 posts total
- 136 posts total