DIY interconnect just arrived ~~navships~~, true High Fidelity

OK hard wired, direct to power trans, Got it,,, hummm not really interested.
Helix IC,,Ok got it,,, too complex for my level. 
Yeah the silver coated copper speaker wire 12 gague,,, due in this week, will upload another YTvid for those who might be interested in that shootout. 
Yeah the navships are worthy to be connected to the Jadis Defy7. 
I mean why sopend $4500 ona  amp + $$$ on mods,, then have some low down generic pull the sonics down??
Navships senta  ebay link to the IC 16 ga wire he uses,,,again, silver coated copper. a  whole bunch of strands. Now i understand why his IC's sound hifi. 
was thinking about employing some of his wire in the Defy and preamp, from the out board to the RCA outs. let  me see what my tech would  charge for that lil mod. 

MOZARTFAN thats fine my point was removing the power cord or having a power cord in the line the sound is the same to me you said the better cord you made sounds the same as the junk cord the amp came with my point is power cords are marketing bs you think so to the ac wall plug 120v 15 amps 14/2 awg wire in the wall put a 12awg power cord on the amp to the plug you will not get 20amps for the amp more juice the way i did it i will get up to 30 amps max for my crown studio ref1 amp that it needs no power cord is not hard to do its cost $0000 to do how much money do good power cord cost you know that all i was saying

Personally, I like the fan aimed @ the amps' tubes....*S*

A bit off topic, but wire connected

I hooked up my Emerald Physics 3.4s, which have outboard power supplies, but the crap jumper wire that was included is, well....

I replaced the CJs with Wire World OCC which was designed for internal speaker wiring. While initially the OCC was 'better', after about an hour it got better and better. Just upgrading the jumpers literally transformed the 3.4s to a much more musical speaker

hth

marketing bs you think so to the ac wall plug 120v 15 amps 14/2 awg wire in the wall put a 12awg power cord on the amp to the plug you will not get 20amps for the amp more juice the way i did it i will get up to 30 amps max for my crown

OK got it,, so direct hard wire to the trans , from  trans connects, direct to wall, skip connect at rear of amp,, OK clear, 
you get more amps... hummm , nah I 'll pass. 
That mod will cost me cash that i can not budget in.
I am happy to have the 12 ga DIY cord,, I am sure Jadis made the read connect acceptable to draw as much current as required by the trans. 
But agree the 2 cent cord that comes with every amp/component you buy,,even jadis' $$$$$$$ amps, no doubt are supplied with that cheap 10 hair thin stranded cord. 
We all have at least 5 in our closet,,everyone should go cut one open,,,you'll see what I am talking about,, Trash that thing and get either navships 12 ga silver coated copper or Home Depot
's THHN 12 ga. 
I see no reason to use navships silver 12 ga, , juice is  juice on any medium of material,,and yes, its very likely the 2 cent power cord actually brings same current amperage as the 12 ga,,At least tahts on specs,,But in actual performance after 5 hrs of use,, the 12 ga will be more consistent/solid current