Rob,,
Sealing between the chambers is important for impulse integrity. If open, the woofer air pressure yanks the midrange around - not good. You can temporarily seal well enough with Mortite or bowl putty.
When I came to New Hampshire in 1996, we had local long-hair wool production in the village. I looked into it for speakers as a venture prospect. I also read the British, etc. opinions which are widespread and respected. But I was never convinced given my own experience. I anecdotally attribute the "British Bloat" partially to the tendency of wool to decouple below about 100 Hz. Changing batting isn't on my radar, but who knows? We never know.
Wire gauge is part of the resistance equation. All design measurements and listening is done with the selected gauge. But there is another element in play. Skin effect / signal penetration depth is frequency dependent. 18 gauge is optimum for tweeter frequencies. Larger gauges are suitable for lower frequencies. Your change from 18 to 15.5 will add a harsh coarseness caused by propagation eddy currents. What I am doing with Straightwire is replacing the 18/2 with 18/4 in a star quad twist. We keep the optimum skin depth while halving the resistance and multiplying common mode noise rejection - these cables are in an electromagnetic soup from the drivers and crossovers. I am assuming that final level tweaking will be required due to resistance changes. I am applying the same star quad regime along with progressively larger gauges to the other drivers, all with promising results.
Carry on and keep us posted.
Sealing between the chambers is important for impulse integrity. If open, the woofer air pressure yanks the midrange around - not good. You can temporarily seal well enough with Mortite or bowl putty.
When I came to New Hampshire in 1996, we had local long-hair wool production in the village. I looked into it for speakers as a venture prospect. I also read the British, etc. opinions which are widespread and respected. But I was never convinced given my own experience. I anecdotally attribute the "British Bloat" partially to the tendency of wool to decouple below about 100 Hz. Changing batting isn't on my radar, but who knows? We never know.
Wire gauge is part of the resistance equation. All design measurements and listening is done with the selected gauge. But there is another element in play. Skin effect / signal penetration depth is frequency dependent. 18 gauge is optimum for tweeter frequencies. Larger gauges are suitable for lower frequencies. Your change from 18 to 15.5 will add a harsh coarseness caused by propagation eddy currents. What I am doing with Straightwire is replacing the 18/2 with 18/4 in a star quad twist. We keep the optimum skin depth while halving the resistance and multiplying common mode noise rejection - these cables are in an electromagnetic soup from the drivers and crossovers. I am assuming that final level tweaking will be required due to resistance changes. I am applying the same star quad regime along with progressively larger gauges to the other drivers, all with promising results.
Carry on and keep us posted.