@retsameht01Well you now know you’ll get as many opinions as people in this hobby. I’m sorry this turned into a long post on philosophy instead of gear. Tough to sum up 40 years in one post.
I couldn’t determine if, after this purchase, a. you are finished aside from a mild tweak or acoustic treatment I or b. this is stage One meaning you’re open to upgrades later.
Source: I did not see your preference for a source. In the case of vinyl and perhaps CDs: “if your gear fails to accurately retrieve the information from the medium, nothing downstream, regardless of quality, will correct that. Or the best electronics, connections, and speakers will do a great job revealing how poor the retrieval. Poorly recorded and mastered programming is also a factor but for another session.
Speakers: Consider starting w/smaller floor-standing or larger bookies. You may find that “full size SUV, while a lot fun to drive, is too much of a hassle to squeeze in your garage every day.” DO NOT consider any Home Theatre speakers. Polk’s RTi/RTi A series receive much criticism playing music from their owners for that reason. RT = Reference Theatre. RTi = Reference Theatre improvedRTi A* = Reference Theatre improved Advanced
Unless you like really bright sound these and other “theater” contoured speakers will wear you out.*First hand experience and many posts by others on the Polk forum. I tri-amped mine removing much of the cause
Used gear: I own power amps bought at 1/3-1/2 original $; subs* ~1/4-1/6 the original $ - NO REGRETS! Used higher-end cable and ICs are always a good idea but get your gear first. *DIY in my future😊 details for another day
Connections*: “go back for seconds on these.” Before you seriously shop for gear buy inexpensive connections. I started w/33 cents/ft 12 gauge! Leave these purchases out of your budget**. BlueJeans Is a great place to start. Lotta bang for the buck. My LCR are wired & connected w/their products. *interconnects and speaker cabling ** like having gas on hand to first fire your engine rebuild
From my experience I’ve become anal retentive about wire gauge. Your results will vary due to nominal impedance, the width, depth, and frequency points or range of impedance dips below 6 ohms. Fortunately for you and me, BJ sells 10 ga. For me 12 ga approaches compromise and 14 ga or smaller is ok to connect tweeters and/or small mids in a bi/tri-wire/amp set up. I have 8 ga in my system. I’m sure I’ll take a tomato or two for this paragraph!
So what ever you settle on, buy your gear, connect, and enjoy your “firsts” for a bit. After you can begin to make rational, calculated decisions concerning the “right connections” for system synergy*. The Millercarbons and other A’gon folks will be happy to guide you through choosing connections to that end*.
I’m not quite there* yet either but I think I’m close. You bet I’ll tap the MCs et al for the final polish for these old ears
