apologies to OP for straying from his/her main topic
Cartridge Opinions - Sorry
Yeah, another dumb "what's your opinion on these cartridges" thread. Back in the late 80's we had dealers where you could listen to the stuff.
So anyhow I have a Linn LP12 with Ittok arm and a 30 year old Audioquest B200L cartridge. I'm running it through the phono stage of a Jeff Rowland Coherence One into a Spectral DMA90 through a set of Kef R300's.
I prefer a little more laid back sound (err on the side of forgiving instead of fatiguing) but I like a lot of upper end detail, precise soundstaging, air, etc.
So far I'm considering an Ortofon Quintet S Black, Hana SL or a Benz wood - something at or below the $1k level.
I'd love to hear any opinions, suggestions, and experiences with those cartridges or others in the price range. I could possibly go higher if there is something out there that really shines for less than $1,500.
Thanks.
So anyhow I have a Linn LP12 with Ittok arm and a 30 year old Audioquest B200L cartridge. I'm running it through the phono stage of a Jeff Rowland Coherence One into a Spectral DMA90 through a set of Kef R300's.
I prefer a little more laid back sound (err on the side of forgiving instead of fatiguing) but I like a lot of upper end detail, precise soundstaging, air, etc.
So far I'm considering an Ortofon Quintet S Black, Hana SL or a Benz wood - something at or below the $1k level.
I'd love to hear any opinions, suggestions, and experiences with those cartridges or others in the price range. I could possibly go higher if there is something out there that really shines for less than $1,500.
Thanks.
- ...
- 188 posts total
Dear @luisma31 : As I already told you you just don't understand about and that's why you posted a wrong question because loading of a cartridge is not because its output level but because its internal electric characteristics and the phono stage ones. It does not matters who whom addresses your question. Your knowledge levels are extremely low. I don't care if you are friend of him that does not changes your wrong question and your comment " all the rigth answers " where exist no answer in the post. R. |
@elliottbnewcombjr, Thanks for the correction! I think it was a lack of sleep mistake. I'd love to hear any opinions, suggestions, and experiences with those cartridges or others in the price range. I could possibly go higher if there is something out there that really shines for less than $1,500.@Klooker, chakster has on this site some very comprehensive lists of cartridges you may want to try to find for your review and should not be to hard to find in the Agon search. |
what would you consider as a high output cartridge? Anything over 3mV2.5mV? Only because this is about the minimum that a phono section designed for MM cartridges will handle properly. But the answer isn't simple. The lower the output of the cartridge, the lower its inductance. This will push the resonant peak created by the inductance and capacitance to a higher frequency *and* amplitude. I've noticed that the lower output cartridges won't ring at audio frequencies but the high output cartridges do (which is why they need to be loaded to sound right). Obviously there is an area where the cartridge would have a bit of of both characteristics. Take a look at this link, it is helpful at explaining what is going on: http://www.hagtech.com/loading.html |
- 188 posts total