Denon 6500 - Am I crazy?

ozzy62

good points, if trying to use the AVR for serious 2 channel music it will be adequate power for efficient speakers, but nothing special for sound quality.

for video, these ’kind of lightweight’ multi-channel amps can do a decent job for 5,7,9,11 channels, by their ability to send power only instantaneously here, there, not needing to send power everywhere simultaneously, so this 11.1 AVR may be good at that.

I want to add, look at the speakers first, i.e. speakers that are good for video, i.e. my DBX, successfully creating a wide center image, are not the best choice for 2 channel music. I toe my music mains in for ’just wide enough’ for 2 people, not wider than that, and dead center is still best.

sooo, pick your video main speakers based on wide enough center, high enough efficiency and lack of bass distortion because they are often too close to rear wall and also often too close to a corner. If 1 is close to a corner, another not, it is again the bass that will be the ’problem’.

Avoiding too much bass in corners is why I don’t like ports, and why so many video systems rely on subs, to get the low bass that has been avoided up front. Just not too much from the sub, and for 2 channel with video, not too little from the front, a tango.

Elliot mentioned about about the center channel. Maybe set you receiver to not have a center and let the front two speakers be the phantom center. You will be amazed how good the front end sounds especially when you get a good amp for your two channel setup. Also Bose is great for the center speaker due to it is all midrange. People sell those little cubes individually pretty cheep  On EBay so you can give it a try and keep
it hidden like he said. Let the receiver balance out the front for you with the built in room correction. 

Thanks for so many great comments.  

One question I had was, @hshifi said

For music side do two sealed subs. 

I might be dense, but if doing 2-channel stereo this wouldn't be available.  I assume he meant if using a AVR with 5.2 or 7.2?

So, I think I'm leaning toward the Rega Planar 6 and Elicit-R.  I can then grow my HT around that if I want.  Now I just got to figure out two Floorstanding units that are impressive but won't break the bank (i.e. < $2k)

Hello,
You can add subwoofers for two channel stereo. If your two channel preamp does not have a subwoofer option you can run your speaker wires from your amplifier to most subwoofers and another set of speaker wires to your front L/R speakers and use the crossover controls on the subwoofers to decide what you want the frequency cutoff to be. A popular place is 50 hz as long as your front speakers can do 50hz. REL, SVS are a few popular names but even cheaper lines have this option. This way your fronts do not have to work as hard and get a lot more detail since they are not trying to go down to 20hz but most speakers bottom is 30-40hz. I prefer sealed subs for music since they produce more detail. The ported subs are great for home theater to get the room shaking with less power.

The second set of speaker wires go from the subwoofer to your speakers. That way when you change the volume the subs follow. Rega P6 is a great TT so is VPI. If you do the Rega do your research on the cartridge. Some carts pick up him from the motor when they get closer. I still would love to have the Rega P6. Best value in the Rega line.