Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

@debjit_g You are correct. Eden Sound Extra Large Solid Brass Spikes in the front AND Regular Hemispikes in the rear.

The angle / tilt (front to back) is very close to the original. It resulted in a slight increase in height.

Overall, the improvement in sound quality and performance (on my hardwood suspended flooring) was significant and immediately heard and experienced versus the stock footers.

SIT-1 monos (when they can be found) are much more expensive than than the SIT-3s. Occasionally you will find a SIT-2 for sale, usually cheaper than a 3. The SIT-2 is stereo and provides that immediacy of a tube SET amp. The Bakoon 13R integrated ($5K used) sounds good with Nenuphars, although I prefer going FirstWatt.

For a preamp, the Pass Lab ones make for a great combo. On the tube side I have used LTA and Backert, with Backert being my preferred choice. Easy tube rolling if you enjoy that.

- Robert

I bought my SIT-1 Mono's (Demo's) for about $500 more than what the SIT-3 goes for new.

@david_ten  hi, Thank you for the tip !  :-) 

It would be interesting to try the sit3 in a dual mono configuration for a more fair comparison to the sit1. All you need is a second chassis, power supply, and then you just move one channel over. Anyone over on the pass labs forum of diyaudio could do it. As I've mentioned earlier in the thread, I found independent power supplies for each channel to be a very substantial upgrade when I did it for my first watt f4s. I think I've said this before too, but it's a really beautiful amp that doesn't get the attention it serves, btw.