Guidance on Speaker Wire

Woots, the brand of balanced signal cable is up to you.  As long as you choose a balanced cable and not an RCA cable.  However, I say that only if your preamp has balanced outputs (many do, in addition to RCA outputs) and your amp has balanced inputs.  If your amp does not provide balanced inputs than this is a moot point.  If that be the case than you are back to maintaining the amp close to your preamp and having to run long speaker cables.  Not the best solution, but for whatever the reason is that you can not locate your electronics in the same room/area as your speakers, you are pigeon holed into a long run of speaker cable.

Stick with Transparent...they will do you right!

I'd recommend that you purchase Mono Amps & place them in close proximity to the speakers.

This would enable you to use SHORT AMPLIFIER Cables (Ideally 3 Ft. or less) & Long Signal Cables, Sound Quality of which are not significantly dependent upon length & can be purchased for a much smaller $$ figure, than Power Cables.

Assuming you are a true Audiophile, this will give you the best SOUND Quality you can get under the circumstances you present.

 

Looking back, I see that you have some sweet Mono Amps, just figure out how to get them close to the speakers.  If you have a basement, the Amps could go there?

Stay with Transparent.
All cable brands sell bulk cable to hi-end custom installers. The cables will pull easier and withstand the physical abuse of retrofit wiring.
Good luck.
At least: No more feedback!