2. speakers
  3. 147808-7805

Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

Cube Audio (Poland) designs single drivers and single driver speakers. 

Principals are Grzegorz Rulka and Marek Kostrzyński.

Link to the Cube Audio Nenuphar (with F10 Neo driver) speaker page: 

https://www.cubeaudio.eu/cube-audio-nenuphar

Link to 6Moons review by Srajan Ebaen (August 2018):

https://6moons.com/audioreview_articles/cubeaudio2/

----------------------------------------

Parameters (from Cube Audio):

​Power: 40 W

Efficiency: 92 dB

Frequency response: 30Hz - 18kHz ( 6db)*

​Dimensions: 30 x 50 x 105 cm

Weight: 40 Kg


* Frequency response may vary and depends on room size and accompanying electronic equipment.
david_ten
rwpollock's avatar
rwpollock
89 posts
 
On a side note, FirstWatt has a new model out.
"The F8 revisits their most popular J2 model but simplifies the front end for just three signal-path devices per channel. It applies current not voltage feedback and improves on the J2 specs on bandwidth and damping factor."

The output impedance is 0.2 ohms, which puts it between the SIT3 and the J2, but far below the SIT1 and SIT2 at 4 ohms.
www.firstwatt.com/prod.html

- Robert
highend666
352 posts
 
The Brinkmann Integrated amp is a great match with single driver speakers 
 
https://www.youtube.com/watch?v=jeK04ZUOoss
rwpollock's avatar
rwpollock
89 posts
 
Do you know the selling price?
debjit_g
280 posts
 
This thread has been silent for sometime...:-)
What are folks using for the speaker cable with their Nenuphars ?
david_ten OP
5,480 posts
 
@debjit_g  I am using cables made by Scott Sheaffer. They replaced my Synergistic Research cables (which were also quite good).
More to discover