Use the Parasound to drive the towers. You will need a front end for it. Sounds like all you need is a streamer/DAC which should be able to talk to your upstairs system over your home network. Once you have it set up and furnished you can deal with room acoustics if you are so inclined.
Basement listing room
So…I have lost the eternal battle over tower speakers in the family room.
However, I know I’m in good company and would like some advice on my Plan B.
Here’s the current family room set-up:
Stereo Listing:
Induction Dynamics ID-1 Tower Speakers
Parasound A21 2-channel amp
Marantz AV Receiver SR6013
Source – mostly Tidal Hi-Res
Additional components for surround sound in same room:
4 Induction dynamic ID-S2 Bookshelf speakers
1 Induction dynamics ID-S2 Center Channel
1 ID-SWC4 Induction Dynamics subwoofer
Induction Dynamics A2 subwoofer amp
My plan is to keep the 5 smaller-profile speakers & sub in the family room for surround sound set up. I’ll shift to using two bookshelf speakers and the sub for music listening in that room.
I can then take the towers downstairs and give them their own home.
Right now, the basement is raw space. Poured concrete floors and walls. Ceiling height of 7’6’ in the main area, and 7’1” in a 2nd section. Rough dimensions 29’ x 41’
I’ve linked to a floorplan with exact dimensions. (I did not clutter the diagram with ductwork, plumbing, support columns, etc, which I know should be considered, but the main mechanicals and noise factors are on the other side of the basement, opposite the stairs, and sufficiently isolated (not shown on diagram)):
https://www.dropbox.com/s/3579jgzeiw8j4l8/Basement%20finish-able%20space.pdf?dl=0
I have two main questions for all the way-more-knowledgeable-than-me folks on this forum (I’m an amateur in this audioworld, though a lover of music since forever).
1) Does creating a listening room in the basement make sense given the space as described above? I can take up as much or as little of that space as needed. If it makes sense, what would be:
a. the ideal dimensions
b. the ideal placement of speakers/components given dimensions
c. the ideal materials? (I don’t have a budget per-se, but would like to find the best balance of quality-for-price. To put it another away, I’m not going to skimp where there are real gains to be had, but I don’t want to cross that line of diminishing returns)
2) What is the best why to maximize existing components without duplicating unless necessary? For example, the Marantz has two zones, I assume it’d make sense to use that feature. I can run wire/cables easily between family room and basement – though some of distances could be long depending on how the room ends up configured.) I marked on the diagram where my equipment currently resides on the main floor above.
a. If I were to improve my current stereo system (DAC, pre-amp, etc?), could those be configured to also benefit the upstairs system? Or do I need independent components for each set-up now? What are your recommendations to bring this system to the next level?
I’m sure there will be a lot of opinions on all this, but I appreciate any help/direction I can get! Thanks in advance!
- ...
- 28 posts total
Space B is a nice size for most tower speaker. You should build a solid wall right on the dotted line. Carpet the floor and use sound deadening tile on the ceiling. The speakers will go on the 18 foot wall. Use the Parasound to drive the towers. You will need a front end for it. Sounds like all you need is a streamer/DAC which should be able to talk to your upstairs system over your home network. Once you have it set up and furnished you can deal with room acoustics if you are so inclined. |
I'm of the same opinion. Share the Preamp/receiver, in another room? That doesn't work for me, either. Will it work? yes. Will it be easy to work on, NO! Never understood zones, unless it was an office space with cubicles, or maybe a "KIDS" zone. Everything is unbreakable, HIGH up and out of reach. What does an inexpensive SECOND receiver cost? Or better yet get a Zpre3 or 2 preamp and use the A21 with it. Talk about sweet. Just need a digital source or two. You would have to add a phono stage if you want to do that. 250-600. on the preamp. I picked up a Zpre3 for 295.00. WONDERFUL little preamp... Sub out, remote sub control, remote, Really cool little pre, I use mine with a C20 Mac, (CRAZY good combo) in the tape loop and a Nord 3 (separate) amps in one enclosure. NC500s. A 2.5 analog system. Two mains, 2 bass bins (a 12k class D amp and an active OXO), and 3 lowrider Subs, all PE 1200 DSP plate amps. Buddy I can get the room HIP hoppin', if you know what I mean. That downstairs system will back out sheetrock nails. We set the rock with nails. then screw it off. The set nails backed out of the sheetrock one night, playing REAL LOUD! (KIDS) 5 years ago... Surround upstairs, Super stereo downstairs. You could get going for the preamp alone, add subs as needed. Have fun, and figure a way.... Regards |
Lol on the “listing” jokes thecarpathian, three_easy_payments, flrun I'm waiting for someone to suggest I rent my basement to a Realtor. But seriously, my bad…I tried to edit it soon as I posted but the edit function appears to allow modification to everything except the subject line. Hoping to avoid the same “move too fast” mistakes with my basement room.
Millercarbon I’ve been a musician my whole life. But my money was spent on my instruments not my audio gear. The equipment listed above I came by through an estate sale. Wherever it falls on the spectrum, I found these Induction Dynamics towers, with Parasound amp, placed properly in the room, to offer a transcendent experience. For me, there is now no going back. So yes, I’m a novice, and yes, your answer is condescending, but still, I’d appreciate hearing where your priorities would be were you in my situation. I’m interested in prioritizing component upgrades in concert with my “move downstairs”. And I’m here to learn.
Thecarpathian I will take your advice on separate components. But as a layman, it seems to me that if the two systems were not being used simultaneously, and if they could be literally 8 feet apart (albeit separated by a floor/ceiling), there must be some cost efficiencies to be gained by sharing certain components via 8 foot up-down connects. No?
Mijostyn
Thank you – this was a very direct answer to my questions. My only follow up is to your “build a wall right on the line”: I’ve read online a lot about “golden means” and various room proportions. Given that I’m starting from scratch, should I delve into this level of acoustical theory? Is it not very relevant given the level of my system? Or did your suggestion already take this into account?
Thanks for the specifics on the system itself. The Zpre3 appears to be an inexpensive upgrade. I will look into that and would be interested to hear what others have to say about that vs other potential pre-amps.
“Just need a digital source or two. You would have to add a phono stage if you want to do that.” Why would I need a phono stage for digital sources? Forgive my ignorance, but I thought phono stages were for turntables.
Thanks everyone! Anyone have specific advice on room dimensions or materials? (I think I have a lot of advice on system set-up coming :) |
- 28 posts total