What is missing here?


In this months Absolute Sound magazine there is a nice review of an amp that many of us would probably consider based not only on the review but on the topology utilized with the amp. The amp in question is the new Air Tight ATM 300R. This amp utilizes the 300B tube and according to Dick Olsher " The Air tight ATM300-R wowed me with countless hours of listening pleasure. It consistently brought to life the full sonic promise of the 300B". Sounds amazing right??


Except, nowhere ( except in the specs section) does it mention that this amp is limited to 9Watts/Ch!! And at that it is putting out about 10% distortion! So not only is the amp severely limited to which speakers one can match it to, but those speakers had better be ULTRA high efficiency. While most experienced a’philes will expect the extremely severe limitations of this kind of max output, how many casual listeners who read this article will realize the extreme limitations that this amp comes with? Certainly none of that is mentioned in the review, which brings up the question...why not??? How many even somewhat seasoned a’philes have made the mistake of matching a flea powered amp with a less than favorable speaker load? Let’s hear about it....
128x128daveyf
@millercarbon Chuck, If you don’t like my thread, I suggest you place it on ignore.
I think the OP isn’t a seasoned audiophile for a couple of reasons:
* if you see an amp that is 9 watts or something on the low watts side, you know this amp will need high efficient speakers in the 100db range. Nobody drives an amp at its maximum volume, so you really have much lower watts than 9 to play with.
* usually the specs section indicates if the watts are class A or A/AB. This in itself is very important. I have read many of this reviewers reviews and he usually states what class watts it provides. * you either match your amp to your existing speakers or you match your speakers to your amps specs. If you have 87db speakers, which aren’t that efficient, I would look at amps in the range of 200 watts or more. If I already had a 9 watt set amp, I would buy 100db efficient speakers. System synergy!
* you need to also look at specs from a reputable reviewer or manufacturer especially if you are looking for efficient speakers. For example, if you read in the latest stereophile recommended components section, they found out that the tekton speaker was rated in the middle 90’s efficiency from the manufacturer whereas the stereophile review tested them at mid-high 80’s efficiency, this is a huge difference. This usually happens in the cheaper line of products. It wouldn’t matter much if you were going to drive them with a 200 watt amp, but if I had a smaller set amp, I’d be upset.
* $15k isn’t that expensive for a quality amp, whether it’s a class A 2 watt amp or a 300 watt class a/ab amp, there is much more to an amp than its watts
I used to always read the specs section first to see price before I decide to read the review. But I am letting both subs to TAS and Stereophile expire....just got tired of reading glorified ads written by gushing reviewers for ultra-expensive equipment, that regular music lovers are not excited about. Only the reviewers seem excited about these products. The devil is in the details, which often are not in these reviews. 
Reading forums and looking at specs is why I was very hesitant to buy Vandersteen model 2’s to pair with my Schiit Aegir. I am glad I did not listen to the opinions out there as the two together sound fantastic and will get loud enough to to shake the house. You can go by specs only but at the end of the day it is your ears that matter.
Why would you consider buying an amp like this in the first place if it puts out that amount of distortion?  There are better choices.