Good tonearm for me is only with removable headshell.
The same with removable cable - you can change length, capacitance etc.
Freedom.
The same with removable cable - you can change length, capacitance etc.
Freedom.
Is a captured good tonearm cable better than a high quality one DIN connection?
I am making a big leap into a $6K Triplaner tonearm that comes with a nice silver captured cable.
I was happy that I was able to eliminate my $4K tonearm cable and would have a direct connection.
But wonder if I should keep using my great tonearm cable with a DIN connection instead. My system is highly resolving and, as we all, want the best sound possible.
I was happy that I was able to eliminate my $4K tonearm cable and would have a direct connection.
But wonder if I should keep using my great tonearm cable with a DIN connection instead. My system is highly resolving and, as we all, want the best sound possible.
- ...
- 23 posts total
Some go one step further and solder the wire right to the cartridge pins... 33% mo-better (from three to two points)...Maybe 25% mo-better ; ) Don't forget the solder join inside the cartridge. https://www.musicdirect.com/Portals/0/Hotcakes/Data/products/000122d8-0000-0000-0000-000000000000/me... |
Ha, very good one @stereo5! I had my Well Tempered rewired (uninterrupted run), and had nothing but trouble with the wire ends breaking off the RCA plugs. But the single-run silver wire looms I got with my Trans-Fi Terminator and and Helius Omega are built far more robustly, no problems. The uninterrupted run really is the way to go, for purists. Use as short a run as ergonomically possible, and butt your phono stage right up behind the table, the amp’s rear facing the table. Or, on a shelf directly under the table, if length allows. |
Tomic, that is exactly what I would do; right to the circuit board at the four points where the wires that were soldered to the backs of the RCA phono input jacks were soldered to the circuit board. Think about it, a .2 mv signal would then not have to go through: solder joint connecting tonearm wire to male RCA plug, RCA plug, female RCA phono input jack on preamp, solder joint connecting input jack to preamp internal wire and finally, internal wire to circuit board. How could doing this NOT make a positive difference. It does. Obviously, I am not recommending this; but it is possible to do to good effect. Boy, those were the days! I think. |
- 23 posts total