Cube Audio Nenuphar Single Driver Speaker (10 inch) TQWT Enclosure

Robert,

The resistors were connected between the positive output of the amp and positive speaker cable connector.  So I wound one end around the WBT positive terminal of the VR and the other end I wound around the banana plug of the speaker cable.  When I asked Vinnie if he suggested soldering the connection to the banana plug, which is probably not a good idea considering possible damage or visual marring of the banana plug he replied:
"It might be a good idea to make that resistor connection better.  Maybe a male banana on one end (to the L2) and female banana jack on the other end (to your speaker cable)."

As to your question about whether the resistors are in series or parallel, I am not technical enough to answer, although my guess is since there is only one resister per channel they are definitely not in series.

BTW I checked out your room.  Beautiful space and great set up.  Despite the height of your ceiling, I think you'll be surprised how the Nenuphars will fill the space.  When I went to this catty corner speaker set up I was shocked how much more height there was to the soundstage. Listening to Cohen Live In London my room took on the dimensions of that enormous hall where the concert took place.  I thought this was strange considering the ceiling height (14') hadn't changed from my previous set up with speakers 3' out from the long wall.  

@stephendunn Thanks for the additional information regarding resistor setup, much appreciated.

That would actually be a series connection. In parallel circuits, electricity is flowing through two independent circuits. If either is cut, the other circuit will be still be conducting electricity (think modern Christmas lights where breaks in the circuit, i.e. a burned out bulb, don't cut out the whole stand). Alternatively, in a series circuit, each component is an integral part of the circuit and if it breaks, no electricity flows (i.e, old Christmas light strands where every bulb needed to be tested to find the fault).

In this case your amp is producing electricity and the positive & negative wires complete that circuit and allow it to flow through the speaker. If the resistor were connected in parallel to that circuit, it would be connected to both the positive and negative terminals of the amp (or speaker). Cut one leg of the resistor and the full speaker circuit is still connected to both terminals, electricity flows, and the music continues.  Instead, you've got it connected in series with the speaker circuit. Cut one leg of the resistor and it breaks the circuit and there's no connection/electricity/music.

Stephen, might be worth looking at Dueland cast graphite resistors. Attach to high quality male and female banana preferably by crimped connections if possible or crimp to spade at amplifier end.

Series vs. parallel.

If the only link between the amp the speaker is through the resistor and then to the cable, then it would be in series.
If the resistor makes a looping connection in addition to the regular cable connection, then it would be in parallel.

It is still not clear to me which Vinnie suggested.
Robert