Ok, well if bi-wiring is now out of vogue, what can you do if you have bi-wired dedicated speaker cables?? My cables are Kimber and they were not cheap. I guess one could simply let two of the four connects just hang loose, assuming they are taped up to prevent shorting the amp, but for some reason, that just doesn't seem like a good idea.
High end speakers without bi-wiring?
Recently, I've read quite a few posts that disclaim the benefit of bi-wiring. The claim is that for bi-wire capable speakers, there is no noticeable difference between bi-wired and single-wired connection, assuming good quality jumper cabbles are used for single-wired configuration.
Then, is there a move from high end speaker manufacturers to forget about the bi-wiring option and just provide single wire for their high-end speakers?
(Well, bi-amping is another issue, but let's not consider bi-amping.)
Then, is there a move from high end speaker manufacturers to forget about the bi-wiring option and just provide single wire for their high-end speakers?
(Well, bi-amping is another issue, but let's not consider bi-amping.)
- ...
- 27 posts total
Bi wiring benefits are not supported by fact just subjectively. So YMMV if you hear improvement. But biamping is a very useful option for some and the only reason I use dual binding posts on KCS models. I do think its the reason most speaker manufacturer offer dual posts. I look at it as buy wire a benefit to cable company's. |
Then, is there a move from high end speaker manufacturers to forget about the bi-wiring option and just provide single wire for their high-end speakers?Note: if the cross-over is a series implementation, as opposed to a parallel implementation, there can only be one set of terminals. Series crossovers are in the minority, but some manufacturers prefer them. Regards, |
My Daedalus Ulysses speakers, and I assume other Daedalus Audio models, have only one pair of terminals. Also, these comments from Coincident Technologies' Israel Blume may be of interest. I take no position on those comments myself, but they certainly seem worthy of consideration based on their source. 08-22-11: BifwynneA logical thing to try would be connecting them in parallel (i.e., both + wires to the + speaker terminal, and both - wires to the - speaker terminal). That will have the effect of substantially reducing overall resistance and inductance. That effect, of course, may or may not be audibly significant or subjectively preferable. Regards, -- Al |
- 27 posts total