High end speakers without bi-wiring?

I used two pair of Clear Day shotgun cables to bi-wire.
I found the low end to be a little better.
This was probably because in doing this I doubled the size of the cables.

Ihcho,

I have always bi-wired my Avalon Avatars.
I've never had 2 pairs of identical speaker cables, at least not premium grade.
I run the better cables on the tweeters, regardless of guage. My Avatars always sound better, this way.

I do not bi-wire, but side-step the issue with those kinds of speakers I own by passing a single wire through both terminals to bridge. Hate the jumpers thing.

Good idea. If going with single wires in that configuration I would do exactly the same.

Although my current speakers in use are designed for single wiring, bi-wiring benefited my previous speakers compared to single wiring with a DIY silver wire jumper.

I had also tried bi-wiring with different sets of cables. Clear Day shotgun and Signal cable. My friend always liked the sound of Signal cable on woofer and Clear Day on tweeter because such setup produced deeper base and clear mid/high. The reverse setup produced more tight base and a bit dull mid/treble.
I still preferred single wire with Clear Day cable alone because with biwire setup the base was a bit muddy and slow to my taste.
Anyway, it was fun to play with biwiring. Even biamping with VK200/VK60.

You have the same signal on both runs of biwire. The treble and bass do not just travel on the cable run you pick for them unless actively filtered.