How it works! From a common man.

Rislone, will clean any type of metal surface, DEAP. It is conductive, it is some type of oil (mystery blend). If you just wipe a rusty surface with it it will start to loosen EVERYTHING. Something stuck in a bore, unless it's welded, USUALLY I can get it loose again.. It won't dry up. It's OLD. It smells good. :-)

It's close to 50/50 50% graphene and 50% of the other in close to equal parts, EXEPT the diamond dust VERY little. Just enough 180 to thin it. BOTTLE and cap. A very little bit goes a long long ways. NO DRIPS!

No it is not guaranteed to do anything but cost you money.. BUT it worked for me quite well.

The never seize can be subbed for wolfer coat. Same or close just a German product. EXPENSIVE. 50-80.00 USD a tube (grease tube) 

Regards

Engine treatment. I think I bought a case 45 years ago, I’m still using it..
Still in the old waxed paper oil cans, its old. LOL

I’ve bought it a LOT of times , through the years. 5-6.00 usd a quart.
Save a little put the rest in your car.. Great cleaner. and lub...Quiet anything down..

Regards

Its at least 50% graphene. Which is how many more times conductive than say, ANYthing else?

The answer, for practical purposes, is some number much less than 1, at least how you are using it.

Graphene is a 2D material. When made into sheets, it conducts very well in the direction of its lattice. When ground up or shredded into bulk like a powder, it is a poor conductor. You would be better off with regular old graphite.

If you like the Rislone (at least for mechanical and electrical), I suggest trying CorrosionX. Probably the only product I have used like this that actually works, and fully lives up to the claims and marketing. Not audio, so hopefully allowed. Check how positive the reviews are on Amazon. Almost nothing gets that good of reviews:

https://www.amazon.com/Corrosion-X-90102-Anti-Corrosion-Lubricant-16-Ounce/dp/B003HFTI0S/ref=pd_lpo_...

And if you fish, the reel oil they make is fantastic too.

Thanks I’ll look into that.

This is why my paste works, well. I’m aware that application of graphene is VERY thin, and osmotic (lack of a better term) in nature and works VERY well in a VERY thin layer. MY thinking (but not proven) is those bonds your speaking of (that lattice) form over time after they settle. The longer they settle the thinner and thinner the space between the two surfaces, to the point of the diamond dust thickness.

It continues to seat, WHY? It’s sharp, VERY sharp, and very hard. SUPER abrasive. Soon the two surfaces have squeezed almost everything out between the two surfaces except, WHAT? What’s left, what is left behind, in the thinest coat possible, and bound by that very small portion of diamond dust? That my thinking..Can I prove it? Let me think on it. Can I hear a GOOD result? A result that I like? So far yes..
Have I dug out the electron microscope, to take a peak. NO :-)

Is graphene, plug and play? LOL I dunno!

Give some things a little time, 2-300 hours. Remove the dampening control on the piece too. Just for a time..

Never seize has very conductive properties, it will all move to the place of least resistance. JUST no drips, it’s mixed wrong.

Regards