2. speakers
  3. 161671-55

Issue with ProAc D40 speaker - any suggestions to resolve the issue

Hi,


I recently bought used ProAc D40R couple of months back, and driving them with Bluenode streamer —> Digital Audio company Marachino Class D Mono blocks.


After a month or so I realized that absence of the sound from one of the ribbon tweeter, showed it to local audio equipment dealer, they fixed the issue (it was loose tweeter harness wire), now I get the sound from both the tweeter.


Recently i compared these speakers against my exiting DIY Audio Nirvana 8” Alnico single driver speaker using ‘Spanish Harlem’ Track by Rebecca Pidgeon, to my surprise Audio Nirvana sounded more clear and I can hear all the details especially shakers in the left back corner and all other details while on ProAc D40r I can barely hear all those tiny details in the background to me that should not happen with ProAc being such great speaker especially with Ribbon tweeter, so just wondering What could be the issue, Can it be a Crossover Caps issue (as the person I bought these from mentioned those were in storage for almost a year and I read it somewhere here on audiogon thread that caps in crossover may go bad if you store it for long time). 

Really appreciate any recommendations/remedies to resolve the issue, eventually i will have take it back to audio dealer but just wanted to check on forum that if anyone else experiences this kind of issue and what was the solution.


Thank you,



listener111
motokokusanagi
189 posts
 
If there is a defect (hard to know without doing a frequency sweep and using proper measurement equipment), it may be a crossover component, wiring fault, or faulty driver. Caps are unlikely to just fail after being in storage for 1 year, but that doesn’t mean there isn’t a fault somewhere.

In the meantime, perhaps do some basic testing with a microphone app. Level match the amp volume to the speaker outputs at a given frequency using a test tone (e.g. 261hz, middle C), then compare the volume levels at different frequencies. Ensure also the volume levels match between the individual left and right Proacs.

Not sure what frequencies shakers are at; going off of hi-hats and cymbals, have your testing include the 2khz-3khz range, and up from there, if we're suspecting there's an issue with treble reproduction. 
listener111 OP
26 posts
 
Thank you motokokusanagi, will try comparing the speakers with level matched though as this will be first attempt to do that so will have to wait and see how it goes.
motokokusanagi
189 posts
 
Sure thing. The crossover frequency should be between 2-4khz. You can verify any gross discrepancies in volume output using your phone, using the old speakers as a control, then the left and right Proacs, and both together. Find some percussive music also and do a sanity check if you find a discrepancy using just test tones. If you find a drop in volume output between the individual speakers of -3db or more, then there's a fault.

Subsequent fault diagnosis would require removing the drivers and crossovers.
milpai's avatar
milpai
2,404 posts
 
Is the bass overpowering the mids/highs? The bass on the D40 is potent.
More to discover