PS Audio BHK versus Benchmark

benchmark has a leaner brighter sound than psa bhk d-stream

if you feel your current system sounds a touch dark or slow, not quite enough detail, then it may be a good move

otherwise, it would be a lateral move with an unwelcome tonality shift at best

The Benchmark gear is a much different sound than what you currently own. It is likely the quietest stack of gear you will hear anywhere, this makes a huge difference to me (maybe not to others). I have a all Benchmark stack, including their StarQuad XLR between the preamp and amp. What I would suggest to you is to get the Benchmark LA4 and AHB2 to your house for a 30 day home trial (nothing to lose). You did not mention what speakers you have but you may need 2 AHB2’s. Talk with Rory Rail at Benchmark and he will help you out. Ask him about the XLR connections too. My sources all use Audience AU24 SE XLR and RCA to the HPA4 preamp (same as LA4 + headphone).

The DAC3B is OK. I got it because I wanted to hear an all-BM stack and it was only $1580. However, the rumor is that this DAC is a little congested with a small soundstage. It does sound tonally great with the HPA4 I have.

I bought a Matrix Audio Mini-i Pro 3 DAC yesterday and will try it out, replacing the DAC3B. I bought the Matrix for a headphone only bedroom system but it should be an interesting comparison with the DAC3. I will keep the better DAC with the Benchmark system. I am eventually looking to get a $5K-ish DAC to go into the Benchmark system. Looking at things like AudioByte Vox, Rockna Wavelight, Halo May Level3.

I personally do not think the Benchmark gear needs much burn in. The designer says none is needed and I agree with that. I have owned a few BM pieces over the years (including the same item 2x). I say this because the 30 day trial will get you hearing the best out of this gear almost immediately.

Thank you both for the insight.  My main speakers are MBL 111f which are terrific, but pretty hungry.  I would probably need two amps.  I’m also dabbling in mods and DIY.  I have a speaker rig that I use in different configurations.  It’s open baffle with a wonderful Voxativ full range driver plus different woofer options.  It doesn’t need much power, but a pair of nice light AHB amps would be really good for bi-amping.  
I’m with you on the Benchmark DAC, I’ve heard it described as sterile.  I am really intrigued by the amps though.  If those amps are really that neutral, then it is really the sound of the source and speakers that you’re listening to.  I could see saving the money on amps by going with the Benchmarks and putting the difference into a next level DAC (I have a really good vinyl system).  
Yyz, interesting DAC suggestions, what speakers are you using?  Thanks for the 30 day trial recommendation, I was thinking about that too.  I’ll give Rory a call next week.  

Benchmark amps are known to struggle with some power and current hungry speakers, and running two will actually make that worse, not better, because it halves the impedance seen.

You definitely want to call them and ask, and when you do know the impedance (nominal and minimum) and sensitivity ratings of your speakers.

Suffice it to say there are many speakers that BHK 300’s will power easily that AHB2 will shut down on and be unable to. 

Whether yours are one of those, I don’t know. Your trial period would reveal, but call them first to avoid wasting time. They know their amp’s limitations, so much so that each time I’ve called with interest in AHB2 they make sure to ask what speakers I’ll be using 

Thanks Kren, I was not aware of that.  I check in the negative column because I tend to change and experiment with different speakers.