I used that acid stain in a 24x24x17H building where I make wine. Results vary with what you want to achieve. Your going to want to seal it. I assume a moisture barrier is under the slab? Your basically etching the concrete with the acid. You can get some really cool results. I don't think you will be walking around in your bare feet. As far as insulation, have you priced foam, where it is sprayed into the walls? Acoustically I would think that would be better than fiberglass.
I'm pretty excited about my new room i'm building
I am fortunate enough to be getting kicked out of my dedicated audio space 12’x16’x9’ to make space for the kids to have separate rooms .I am remodeling a stand alone building on my property.The dimensions are 16’x24’x9’ with 10"thick cement floor.I am open to either treating and painting the floor or a floating pergo style floor ( no carpet ) with floor rugs .the walls are drywalled 2x6 construction insulated with redwood board and batten exterior, above the ceiling is insulation with open attic area(which I could add more insulation). As a few of you know I am fully off grid and generate my own power thru solar and gen backup into large battery banks then inverted to my house etc.The only furniture per say will be three reclining chairs etc .I will transfer a lot of my treatment panels and add more as needed. Also I will be trying to set up a humidity and temp control for this room when not in it, I was thinking 60deg 60% humidity .thoughts?
Any tips or thoughts are appreciated .
Thank Ray
I still will have my home theatre setup which is pretty nice in the house also so i’m stoked .
Any tips or thoughts are appreciated .
Thank Ray
I still will have my home theatre setup which is pretty nice in the house also so i’m stoked .
- ...
- 76 posts total
- 76 posts total