2. amps-preamps
  3. 162735-22080

ARC SD135 will not turn on -- fearing the worst

Yesterday my Audio Research SD135 power amp failed. I turned it on, and the amber protect light quickly turned to green---and then winked out. Then, nothing. Replacing the fuse changes nothing. I have an old ARC D130 that I was able to swap in; it and the rest of my system are working fine.

I sent an email to Audio Research service.  Actually, I replied to a previous note from them about the service they were performing on this same amplifier.  A few years ago, they replaced a bunch of parts and sent it back, and the amp has seen only light use since then.  In his note, Kalvin mentioned problems with the ThermalTrak transistors.  I noticed a recent thread that claims these parts are no longer being made.  And Kalvin has retired.  I hope ARC can do something for me.  Any suggestions?

By the way, my power amp is fed by an ARC LS 27, and the speakers are Vandersteen Treo.

rach_fan
russ69's avatar
russ69
3,497 posts
 
Pray it's not the power transistors.
rach_fan OP
25 posts
 
Here's ARC's response to me:

Summary: Since your last repair, the SD135 has made it to the list of products that can no longer be repaired by Audio Research. The same parts Kalvin mentioned below are no longer manufactured and no suitable replacement parts exist. I'm afraid I can only give you the bad news that we will not be able to repair this amplifier for you. We no longer take them in for service.

It's a polite response, but it feels like a gut punch.  They are leaving me completely in the lurch.  They regard this amp, which was a champ 3 days ago, as a piece of scrap metal that I'm going to have to pay to dispose of.  

I understand the problems with unobtainable parts, but this sure doesn't seem like a way for ARC to retain customers.

twoleftears's avatar
twoleftears
5,318 posts
 
I wonder if there are any specialized independent techs who could work on it, now that AR wants no part of it.
rach_fan OP
25 posts
 
A follow-up from ARC, with some suggestions:

Dear David

Summary: I'm sorry but yes, we can no longer accept these units into our service department. With parts unavailable, there is nothing we can do short of redesigning the amplifier and this is not feasible for us. 

There may be technicians willing to tackle this project but we do not have any on a list or anything to share. It would be something you'd have to find on your own. 
450
As for used amps, if you're looking to stick with solid state, we'd suggest looking at a D240, DS225, or DS450. Those amplifiers are still fully serviceable and will be for the foreseeable future.


rach_fan OP
25 posts
 
Here's a thread from two years ago, about another broken SD135. In this poster's case, ARC gave him a credit toward a new amp. The thread discusses the ThermalTrak transistors, which had been discontinued. There's a new version of those parts, but it's not compatible with ARC's design. Apparently, ARC never found a workaround using the new versions of the parts.

https://forum.audiogon.com/discussions/my-amp-is-broken-not-sure-what-to-do-any-recommendations/post?highlight=sd135&postid=1637744#1637744

ARC service suggested that used ARC models D240, DS225, DS450 might be of interest. Perhaps a used Ayre power amp might also be a candidate. My preamp is an ARC LS 27, and the speakers are Vandersteen Treo.

Thanks!
More to discover