2. cables
  3. 163171-155898

Spades vs Bananas vs Bare Wire Treated with Caig Deox

There's been a myriad of good discussion on terminations for high end speaker cable.  Spades vs Ban vs bare wire etc.  After much deliberation, the variability in termination contact material and the cost, my conclusion is to forgo any spade/ban termination and run bare 12 awg 200+ strand OFC copper wire.  I plan to simply treat the connection with Caig Deoxit D and Gold series.  

According to their literature the connection is protected on average 5 years.
https://caig.com/questions-answers/#toggle-id-2

Its not the neatest setup, but this is a set it and forget it home audio set-up with sub $5K in equipment in a climate controlled basement that stays 68 degrees year round.  I'm new here and in no way poo-pooing the decision for terminations.  For me, it seems like work I don't need to take on unless someone told be the channel output could be increased by a few db and the distortion decreased by 20+%. 

Anyone see an issue with this reasoning?

Other post history: https://forum.audiogon.com/discussions/spade-vs-bare-wire

cp1999
cp1999 OP
2 posts
 
Its a 7.1 system so I need ~100ft.
I'm in the sub $200 range.  I bought the Sewell Silverback stuff.  The reality is, I'm in the mid audio class range with my equip (Denon AVR 891, Klipsch RP-8000f).  Spending $1000 on cables isnt going to buy me much.  I'm looking for good as I can get thats reasonable.

Post removed 
audio2design
1,351 posts
 
Don't do this.

Be aware that it’s best to tin the ends of bare wire with solder to reduce the possibility of breaking individual wire strands.

Do this
About the problem of breaking wires or stray wires shorting, a little dab of solder on the bare wire ends will normally take care of that.





glupson
7,842 posts
 
"...literally not one single person on the whole planet, is going to want my $7500 cable once I've chopped the terminations off. Couldn't give them away."

I'd take them for free (and screw my banana plugs on them ASAP).
noromance's avatar
noromance
9,938 posts
 
Meh...I do not use plugs. Bare wire removes another break and joint in the path. Instead of spending a fortune, look at Neotech OCC cable on PartsConnexion. There's a new thread on 'DIY Neotech' and search for mine with 'UP-OCC'.
More to discover