Speaker Rake

I replaced the spikes on my Grand Veena speakers with BDR cones, and then put small ceramic tiles under the back ones to slant the speakers forward.

The speaker instructions state that if you sit closer to the speakers this sounds better than the standard rake.

I would agree, so experiment with your seated position and try raking the speaker forwards or down as opposed to tilted back.

And as far as what this hobby is about, it shouldn't be about compromise and setlling for second best, if you have the means to make the music sound better, why not?

It doesn't mean spending big bucks either.Sometimes all it takes is a little effort , like moving the speakers around.

Some folks are easy to please, others are not.
Some folks like remote controls, others don't if they mess the sound.

Nobody has all the answers,but we should all strive to make the best we can with what we have.

Funny I have vandy 7 and have been dealing with this same issue. I find in my room if I stand or lean foward the base is a bit fuller. I actually moved my seating position up a bit and the sound improved. I have not had hours to experiment but I have a feeling for me it is the room itself or the sofa I am sitting on has a higher back and is sucking/absorbing the sound. One of these days I will move the sofa and put a chair there to hear the difference.

Hello K rose,
I have set many a speaker and have a formula that works for me. First assuming that you have your basic placement, i.e. how far from the sidewall/backwall and width set. On Talon Firebirds, you focal point will be half way between your ceramic mid and tweeter. Start with a full tow and have your left speakers focal point towed in pointed directly at your left ear, right focal point pointed directly at right ear.... Listen adjust rake angle at this point, still getting the focal point between the tweeter and mid pointing at your ear. You should now have very good imaging, but depending on room character and speaker response curve, you could be too bright. If so, start moving your tow outward by only a quarter inch or so at a time always maintaining rake angle. A quarter inch speaker movement will result in 2 to 6 inches at the ear depending on distance of speaker to ear. Listen.... continue to move outward until tonal balance is there and you are not distroying your soundstage. Somewhere there will be a fine line that you will need to decide about sound stage or tonal balance. If you have a great room and very flat speakers, it is possible, you will keep it pointed directly at your ears without towing out. Some speakers are designed to be pointed straight forward, if that is the case, you could slowly turn them until you like this best, but in any case, your rake angle will be set. Good luck, Tim

I found some butcher blocks that fit my Silverline Preludes exactly...painted them (2 under each speaker) black and they look like they were always there. It lifts the speakers up about 4 inches which is all I and they needed it seems. D'apolitos need to be flat. Also, I use Vibrapods under the speakers...that works amazingly well for reasons I refuse to understand. I also don't understand why visual cues don't do the job that lasers do...can't you "see" the toe in degree or level from the speaker edges? I sense a laser sales conspiracy simmering...