Reed 2gTonearm Torn Wire & rewiring HELP please


I have unfortunately torn my Reed 2g tonearm cable at the proximal end where it plugs in - I was unable to remove the cable from where it plugs in to the main central part of the arm - it seems to go into a piece of stainless steel but I was unable to move this, slipped and snapped the wire . Anyone know how the cable is removed at that end?
As it was I received the tonenarm assembled so I did not see how this went together
The second question is how do you insert the cable at teh proximal end as it goes in through a very small hole ...is this something that only Reed can do?
docfar
docfar, That is a fine tonearm. It comes either hard wired or with a 5 pin DIN connector which is round and both channels head into it. It is keyed usually slides into a barrel and there may be a set screw that locks it in.
If it is hard wired you are in trouble unless you are good with a soldering iron. At least the arm wand wiring is OK. You will have to take the junction box apart, cut the last 1/2 inch off the cables, trim them and solder the ends to the terminals inside which you will have to clear first. I would have no trouble doing it but there may be a tech near you also.
If it is a DIN plug you will have to remove the plug from the barrel and buy a new cable. There are a bunch on the market.
Only a doctor uses the phrase "proximal end". 
I assume he is not a neurologist. A neurologist would figure out the wiring.