2. amps-preamps
  3. 1107576063

Why does my Adcom GFA-2535 blow fuses?

I'm trying to run an NHT AudioCenter 1 with the B side of an Adcom GFA-2535. It runs fine on just one side, but when I bridge it, one or both of the internal fuses blow after just a few seconds. It's an 8 ohm speaker, and is hooked up as stated in the manual. Any suggestions???
jays
jays OP
5 posts
 
Thanks for all your help...I'm going to have it serviced because I'm pretty sure it's either a resistor or capacitor short. Appreciate the help, now I know what to look for when they tell me what the amp needs!
chrispdx
10 posts
 
And yet another resurrected thread from almost 16 years back ... @jays I also recently acquired an Adcom 2535, wonder if you were able to get it working properly and any other feedback or advice you have on that piece? Thanks!
213runnin
914 posts
 
Good lord, jays has 5 posts to his name in 15 years.  I don't think he's around, you'll have to either get it serviced, shelf it or trash it.
More to discover