recommendation for rca interconnect for deeper bass for dac to preamp

https://www.ebay.com/itm/Viborg-VS903-Speaker-Cable-Wire-DYNAMIC-PERFORMANCE-Series-17AWG-HiFi-Audio...

<<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>>>>

This cable is really cool to, I use pure copper eyelets, not spade connectors, and cut the opening with a die grinder.. Solder, seal, armor(option) and cook.. BASS perfect, for mid/bass speaker runs.


Oil?


Actually good bottom to top, perfect for horns. You should hear the older Klipsch with this cable. I’ve NEVER heard better, and heard a LOT worse.. at 100 times the cost.. 100.00 usd vs 10,000.00 usd.
A C note cable beat the pants off Transparent, and MIT. (not hard to do). Easy to match.. A few years back too..

Viborg is tough to beat...

oldhvymec,

17 awg, and high inductance --- not a great target for a cable, but they sure are purdy!

audio2design986 posts02-05-2021 11:18amoldhvymec,

17 awg, and high inductance --- not a great target for a cable, but they sure are purdy!
 Report this
<<<<<<<<<<<<<<<<<<<<<<<>>>>>>>>>>>>>>>>>>>>>>>>
The oil/tube RCA
A2D, what the heck does oil do? You're all about the science.  Why does it change the wire sound? I drained one and took one out of the silicone cover, all 3 sound different, the oil though... It is really weird.

The speaker IC
The twisty copper conductor, was an  AGon idea, "Use copper tape" is how that started.. 15 years ago and again three years ago.  Then the twist shows up in China.. LOL I think they track AD on the down low...
The money folks are willing to spend, why not?

They are weird looking, that's for sure, No folding either. I didn't measure the bare cable or with ends.. I don't use it, now,  BUT I have.. Great sonics, for round speakers, horns, domes, rings..
Planars/ribbons.. not so much.

It's always copper that comes to the rescue, heavy copper.  What are most of the voice coils wound with? Copper...
I NEVER had a lack of bass, too much.. that's pretty common..

280hz and up planars and ribbons for me.. Who know what they use. :-)

Regards

@oldhvymec
took the last 2 pairs (actually needed 3) so I'll report back when they arrive

All the twist does is make the wires farther apart (higher inductance) and make the wire effectively longer (higher resistance).

Expect the oil would not do a lot. Already have air around it.