Dedicated power

residential electric service is 240VAC, which is achieved using two 120VAC lines that are 180 degrees out of phase with each other.

They are 180 degrees difference when measured to neutral not each other.

People may balk at this, but it is my experience.  I ran two 20amp dedicated lines from the first breakers in the panel, everything else on a different leg, 10 ga. Solid core, in conduit, straight run, to the outlet box. Also placed a separate grounding rod for these two lines. While the improvements were vast, noise from all the household appliances, etc. Were still present. The solution was to use isolated ground hosp. Grade outlets sharing the grounding rod. Cleanest, strain free, quietest power I have ever experienced. Art Audio High Current Jota mono blocks on one line, original Hydra on the other feeding preamp, digital sources & analog sources.  I have shared this on a few boards over the years, but never known anyone to take this suggestion.

FYI, You may not use a ground that is electrically separate from your service entrance ground.  Doing so violates the NEC and is a safety hazard.

You may add additional ground rods to the original circuit however.

You may add additional ground rods to the original circuit however.

Please correct me if I'm wrong, but I believe this is what I have done, the two isolated ground outlets have a shared ground rod which is an additional ground point in the system.