FTC may end amplifier rule! ACTION NEEDED

"I had a Denon X6500H for example that is rated 140 wpc,  2 CHANNELS DRIVEN.   Gene tested it with 7 CHANNELS DRIVEN and the wattage was only 64 wpc or so."        That’s EXACTLY what’s to be expected, with a component of more than two channels.      ESPECIALLY: comparing TWO channels driven, to SEVEN.      What’s your point?

@rodman99999 first, the statement about my experience with denon was to give an example of what russ was bringing up. It’s an understanding of what he brought up. Denon does not publish their power ratings for 7 channels driven is the "point". They publish it at 140 wpc for 2 channels driven. So without an amplifier rating policy in place (whether or not this would be actually enforced) they could presumably publish their rating as 140 wpc for 7 channels driven. This would be completely false by any count of course. They could also publish distortion at 120db across the whole frequency spectrum if they wanted. Isn’t that point enough for an audiophile to care?

The way that Denon is rated and what it outputs, driving seven channels, isn't an, "example" of anything.        It's capable of 11.2 channels.      You expect every HT receiver company to list the output of their components, into every conceivable system/channel configuration and impedance/load?     Positing/assuming (everyone's crooked) = HILARIOUS (HEP ME, Big Brother, HEP ME)!

@rodman99999 why not expect truth in specs? Specs are supposed to tell you the technical aspects of components. An average consumer may assume the denon to produce 140 watts per channel 11 channels driven. The only reason I can quote the 64 wpc is because someone bothered to measure it.

"... The only reason I can quote the 64 wpc is because someone bothered to measure it..."

I can't remember the requirements of the FTC method exactly but the FTC measurement only requires two driven channels. So multi channel amps are exempt from testing that might be more telling. So there is another reason the FTC requirement is obsolete and doesn't help the consumer. Frankly, I go by weight. Big iron and big toroid transformers weigh a lot and tell you more about power capabilities. So I say the weight per channel measurement is what consumers need to know. Perhaps with a class D correction factor, LOL.