FTC may end amplifier rule! ACTION NEEDED

Russ. I think we both can agree on this. There's something special about heavy amp. You bitch and complain as you get it into place but a part of you knows it's the real deal. I love 5 channel amps with two toroids. I auditioned the NAD c298 and it was sp clean and pristine. Class D purifi tech at 180 wpc. It was ultimately too neutral for my liking but I'm sure most would love it. 

@eric_squires yes. This is a fair question and I'm not trying to stir any pots... but do you think the future is well made class D amps? I feel like class AB has hit its peak and class A can't get any better. That leaves room for improvement in class D and H. 

Less government the better.

I have never purchased any piece of equipment or a machine based on a spec sheet.

actually, i find the FTC requirements arbitrary. Music is not a 100% duty cycle into an 8 ohm resistive load. Having short term current and power capability is far more important than being able to, say drive a 75 watt signal into an 8 ohm resistor for an hour.

Well recorded music has a peak:average ratio of over ten. This means that, to avoid clipping, an amplifier ought to put out less than 10% of its maximum voltage swing on average. OTOH it is VERY useful for it to have the ability to drive nearly zero load momentarily, given the very reactive properties of most cone speakers (with the voice coil flying in the reverse direction its theoretically possible to be negative in fact).
The simplistic requirement is a bane, IMO. I realize it is nearly impossible to make anything simple meaningful, but this really does not bother me one bit. Not one’s allowing them to lie, simply to stop measuring "20-20k, both channels driven, for an hour, into a 8 ohm resistive load". Of course, I’m one of those misleading designers intent on selling you something that sounds good, but is really a pile of crap :-)


Note the biggest hurdle is the most fallacious: its heat dissipation.
note2: for any class-A amp this is all irrelevant and for hgih bias AB far less relevant.
note3: read specs at 8, 4 and 2 ohms to get a good idea of real capability.

"...   but do you think the future is well made class D amps?..."

The advantages of low heat and low power consumption will always be in demand. For most applications that might make it the dominant design but I'm not ready to write off the other class amps quite yet.  

You mean the 1,000,000 watts RMS per channel they told me my amp had wasn't true?