Allnic 1201 replacement tubes?

@pops I found the tool , it is very difficult to pull tubes , you’re right ! What a hassle . On top of that , now my left side is acting up , low volume and not as full , like a cold solder joint , 😫 even changed tubes , same result . 

Hi Tommy
I need one of this tool, do you know were I can find one
Thanks
Francesco

@francozi 
I’d come contact Albert Porter , he’s your man . Hooked me up with new Allnic 1202 , great guy . Good luck ! 

tommy, did the left channel problem occur before or after you had attempted to pull tubes (with or without the tube puller)?  Also, have you now replaced the old tubes with new?  Simplest thing to do first is to swap the tubes on the R channel with those on the L channel, and see whether the problem flops over to the R.  If it does, then go back to the old tubes or install the new ones, whichever you have not done yet.

@lewm 
pretty sure its a cold solder joint in my Manley preamp , it seems to have gone away for the time being ...

I've swapped tubes L/R , its really intermittent ...